Section 4: Operation
OPERATING THE TRIMMER / MOWER
Once you have read and understood the sections in this Manual on “Safety,” “Features and Controls,” “Assembly,” and “Operation,” you are ready to start and operate your trimmer/mower.
“START” position to start the en- gine. (Use short starting cycles
WARNING
If the control bail is not oper- ating properly, shut off the engine, disconnect the spark plug wire and move wire away from plug.
Adjust or repair the control bail before using the trim-
Checklist Before Starting:
1.Complete the
2.Check that the line cutting height is adjusted according to the instructions.
Starting the Engine
1.Move the trimmer/mower to the work area.
2.Connect the spark plug wire to the spark plug (if not connected).
3.Put on
4.Start the engine as follows:
Recoil Start Model—
a)Put the engine ON/OFF switch (A, Figure
b)Move the engine throttle lever (B, Figure
c)Push in the fuel primer button (C, Figure
d)Pull recoil start rope slowly until resistance is felt. Then pull rope out rapidly to start engine. Let rope back in slowly. Repeat if necessary.
Electric Start Model—
Follow Steps 1, 2, 3, 4a, 4b and 4c given previously.
e) Turn the ignition keyswitch to the
Power Up the Trimmer Head
1.Stand in the operator’s position directly behind the handlebars.
2.Slowly close the control bail (D, Figure
3.Once the trimmer head is revolving, push the trimmer/mower along the path to be cut.
To Stop the Trimmer Head
Let go of the control bail (D, Figure
To Stop the Engine
Put the engine ON/OFF switch in the OFF position. (If time allows, first move throttle lever to SLOW setting before stopping engine.)
mer/mower.
Failure to follow this instruc- tion could result in personal injury or property damage.
B |
C |
A |
3x |
Figure |
D
Figure
9