Troy-Bilt 52058, 52057 owner manual Safety Decals

Section 1: Safety

2.Never run the engine inside a closed area.

3.Never clean, or make adjustments or repairs with the engine running. Disconnect the spark plug wire and keep the wire away from the plug to prevent accidental starting. Remove key on electric start models.

4.Keep all nuts and bolts tight, espe- cially the trimmer head attachment bolts, and keep equipment in good condition. Check mounting hardware on trimmer head every time you change trimmer line and prior to each use.

5.Never tamper with safety devices. Check their proper operation regularly.

6.To reduce fire hazard, keep mower free of grass, leaves or other debris build-up. Clean up oil or fuel spills. Let machine cool before storing.

7.After striking an object, stop the engine and disconnect the spark plug wire. Inspect the machine and repair, if necessary, before restarting.

8.Never make adjustments or repairs while engine is running.

9.Components subject to wear, damage and deterioration could ex- pose moving parts or allow objects to be thrown. Frequently check compo- nents and replace with factory recom- mended parts, when necessary. Regularly inspect the trimmer head

and debris shield. Make sure they are not bent, damaged, or loose.

10.Only use eighteen-inch long .130" or .155" diameter trimmer line. Never use other lengths, diameters or material as trimmer line.

11.Trimmer line moves

at high speed and can cut. Always stop the engine and let all mov- ing parts stop before

replacing the trimmer lines. Let the engine cool.

12.Do not change the engine gover- nor setting or overspeed the engine. The governor controls maximum safe operating speed and protects the en- gine and all moving parts from dam- age caused by overspeed. Authorized service shall be sought if a problem exists.

13.Do not touch engine parts which may be hot from operation. Allow parts to cool completely before in- specting, cleaning or repairing the unit.

14.Maintain or replace safety and in- structional decals. Refer to the Parts List for replacement decal information.

15.Use only original-equipment replacement parts. Parts manufac- tured by others could present safety hazards and affect performance even though they may fit on this machine.

16.Remember – the end of the sea- son is a good time to inspect equip- ment prior to storage.

17.To guard against engine overheat- ing, always keep the engine debris guard mounted and clean.

18.For units equipped with electric start:

a)Batteries produce explosive gases. Keep sparks, flame, cigarettes, etc., away. Ventilate area when charging battery. Do not charge battery in an airtight space.

b)Do not use a battery charger other than the one provided with the unit.

c)The battery contains toxic mate- rials. Do not damage the battery case. If the case is broken or damaged, avoid contact with the battery contents.

d)Properly dispose of a damaged or worn out battery. Check with local authorities for proper dis- posal methods.

e)Do not short circuit the battery. Severe burns and fire can result.

Safety Decals

Make certain that all safety decals on this equipment are kept clean and in good condition. The decals are shown (at reduced sizes) below. If you need a replacement decal, refer to the Parts List in this Manual.

WARNING

THROWN OBJECT HAZARD

•Objects will be thrown violently by the cutting head, resulting in significant hazard!

•Keep children, pets and bystanders 50 feet away from machine while operating.

•Be alert to hidden obstacles.

READ OWNERS MANUAL

If you need a replacement manual, write to the address listed on the serial number decal on this unit.

ROTATING CUTTING HEAD

Do not service or adjust cutting head or other moving parts unless engine is stopped and spark plug wire is disconnected.

1918115 (12/99)

At front of deck

On engine, above muffler

On left

handlebar

3