Troy-Bilt 630C-Tuffy manual Checking And Adjusting, E B, Forward Drive Belt Tension

WARNING: Before inspecting, cleaning or servicing the machine, shut off engine, wait for all moving parts to come to a complete stop, disconnect spark plug wire and move wire away from spark plug. Failure to follow these instructions can result in serious personal injury or property damage.

					b Unthread the hex nut (C, Figure 5-4)
					halfway up the adjustment screw (D).
					c. Unhook the top of the spring from
					the Forward Clutch Bail.
					d. Use pliers to prevent the adjuster (B)
					from turning and turn the slotted screw lo-
					cated inside the spring clockwise (viewed
					from operator’s position) to increase ten-
			D		sion on the spring. Turn the screw coun-
					terclockwise to decrease tension. Once
					adjusted, reattach the spring to the For-
C					ward Clutch Bail.
					e. Repeat Steps 2 and 3 to re-measure
					the length of the spring. When the second
					measurement is between 1/16" -to- 3/16"
A				E B	longer than the first measurement, retighten
					the hex nut (C) against the top of the adjuster
					(B).
					Replacement Belt Information
Figure 5-3: Install tines so that cutting edge of tines enter soil first when tiller moves forward.
					If the drive belt needs to be replaced, see
CHECKING AND ADJUSTING	belt tension is correct if this second mea-				your local authorized dealer or refer to the
FORWARD DRIVE BELT TENSION	surement is between 1/6" -to- 3/16" longer				Parts List for ordering information. Use
					only a factory-authorized belt as an “over-
It is important to maintain correct tension	than the first measurement.
	4. If the spring is too short (less than				the-counter” belt may not perform satis-
on the forward drive belt. A loose belt will					factorily. The procedure requires average
	1/16"), the tension is too loose. If the
cause the tines and wheels to slow down —					mechanical ability and commonly available
	spring is too long (more than 3/16"), the
or stop completely — even though the en-					tools.
	tension is too tight.
gine is running at full speed. A too tight
	5. To adjust the length of the spring:
belt can result in unintentional tine move-
ment when the clutch bail is in the Neutral	a. Release the Forward Clutch Bail.
(released) position.
					5
• Check belt tension after the first two
hours of break-in operation and after every					4
10 operating hours.				3
• At the end of each tilling season, check			A	2
the belt for cracks, cuts or frayed edges
		C
and replace it as soon as possible.				1
		B
To Check Forward Belt Tension:
				D
1. Stop engine, wait for all parts to stop
moving and disconnect spark plug wire.			Hold bail against handlebar while
2. With the Forward Clutch Bail in an open
			taking second measurement of spring
(released) position, measure and note the
overall length of the cable spring (A, Figure
5-4) by measuring from the outermost coil
to the outermost coil.
		Figure 5-4: To check forward belt tension, take two measurements of the
3. Squeeze the Forward Clutch Bail
		overall length of the coils in the spring — first with the clutch bail open,
against the handlebar (see Figure 5-4) and		then with the clutch bail closed against the handlebar.
re-measure the length of the coils. The
			19