![](/images/new-backgrounds/1123473/12347325x1.webp)
Figure | Figure | Figure |
5
Making
Adjustments
You can also check the adjustment as follows:
1.With the snow thrower tipped forward, remove the frame cover underneath the snow thrower by removing the
2.With the drive control released, there must be 1/8” clearance between the friction wheel and the drive pulley in all positions of the shift lever.
3.With the drive control engaged, the friction wheel must contact the drive pulley. See Figure
4.If adjustment is necessary, loosen the lower hex nut on the drive cable index bracket and pivot the bracket upward or downward as necessary. Refer to Figure
5.Reassemble the frame cover and return the unit back to its operating position.
Skid Shoes
The space between the skid shoes and the ground can be adjusted.
•For close snow removal on a smooth surface, raise skid shoes higher on the auger housing.
•Use a middle or lower position when the area to be cleared is uneven, such as a gravel driveway.
To adjust the skid shoes:
1.Loosen the four hex nuts (two on each side) and carriage bolts. Move skid shoes to desired position.
2.Make certain the entire bottom surface of skid shoe is against the ground to avoid uneven wear on the skid shoes.
3.Retighten nuts and bolts securely.
NOTE: Some models are equipped with reversible skid shoes and may be turned over to increase their lifespan. See Figure
IMPORTANT
It is not recommended that you operate this snow thrower on gravel as loose gravel can be easily picked up and thrown by the auger causing personal injury or damage to the snow thrower.
If for some reason, you have to operate the snow thrower on
Auger Control
To adjust the auger control, refer to page 11.
gravel, keep the skid shoe in the highest position for maximum clearance between the ground and the shave plate.
13