Controls and Features

4

 

 

 

Drive Control

Shift Lever

Auger Control

 

 

 

Electric Start Button

 

 

Gas Cap

 

Chute Directional Control

Chute Assembly Oil Fill

 

 

Clean Out

 

 

Tool

 

Engine Controls

 

 

 

 

Recoil Starter

 

 

Handle

 

 

Electric Starter Outlet

 

 

Primer

 

 

Ignition

 

 

Key

 

 

Choke

 

 

Control

Augers

Skid Shoe

Throttle

 

 

Control

 

 

 

Figure 4-1

 

Snow thrower controls and features are described below and illustrated in Fig. 4-1.

NOTE: For detailed information on all engine controls, refer to the separate Tecumseh Engine Operator’s Manual.

Shift Lever

The shift lever is located in the right side of the handle panel and is used to determine ground speed and direction of travel.

Forward

There are six forward (F) speeds. Position one (1) is the slowest and position six (6) is the fastest.

Reverse

There are two reverse (R) speeds. One (1) is the slower and two (2) is the faster.

Choke Control

The choke control is found on the rear of the engine and is activated by rotating the knob clockwise. Activating the choke control closes the choke plate on the carburetor and aids in starting the engine.

Ignition Key

The ignition key is a safety devise. It must be fully inserted in order for the engine to start. Remove the ignition key when the snow thrower is not in use.

Note: Do not turn the ignition key in an attempt to start the engine. Doing so may cause it to break.

10