Assembly & Set-Up

3

 

 

 

Contents of Carton

 

•

One Snow Thrower

•

Two Replacement Auger Shear Pins

•

One Chute Assembly

•

One Snow Thrower Operator’s

•

One Tecumseh Engine Operator’s

•

One Product Registration Card

 

Manual

 

Manual

 

 

Assembly

Handle

1.Place the shift lever in the forward-6 position.

2.Observe the lower rear area of the snow thrower to be sure both cables are aligned with roller guides before pivoting the handle upward. See Fig. 3-1.

Figure 3-1

NOTE: Make certain the upper ends of each cable are seated properly in its bracket.

2.Secure the handle by tightening the plastic knob located on both the left and right sides of the handle. Remove and discard any rubber bands, if present. They are for packaging purposes only.

Chute Assembly

1.Position the chute assembly over the base. See Fig. 3-2.

2.Close the flange keepers to secure the chute assembly to the chute base. The flange keepers will click into place when properly secure. See Fig. 3-3.

NOTE: If the flange keepers will not easily click into place, use the palm of your hand to apply swift, firm pressure to the back of each.

Figure 3-2

Figure 3-3