SECTION 2: ASSEMBLING YOUR CHIPPER SHREDDER VACUUM
Unpacking
•Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open carton.
•Remove loose parts if included with unit (i.e., operator’s manual, etc.)
•Cut along corners, lay carton down flat, and remove packing material.
•Roll or slide unit out of carton and check carton thoroughly for loose parts.
Loose Parts In Carton
Following is the list of loose parts shipped with your equipment. Compare the parts with the illustration in Figure 1 to identify these items.
1.Nozzle
2.Bag
3.Chipper Chute
4.Tamper Plug
5.Oil (Not Shown)
Bag
Nozzle
Attaching The Nozzle
•Remove three wing nuts from the front of the chipper shredder vacuum.
•Place nozzle in position over the three studs on unit and secure with wing nuts just removed.
See Figure 2.
Wing
Nuts
Wing
Nut
Nozzle
Figure 2
NOTE: The metal tab on the nozzle must depress the safety switch button attached to the front of the chipper shredder vacuum or the engine will not start.
Attaching the Chipper Chute
•Loosen, but do not remove, the two hex bolts, flat washers, and flange nuts which are secured to the support bracket. See Figure 3.
Chipper Chute
Tamper Plug
Figure 1
Before Assembly
IMPORTANT: This unit is shipped without gasoline or oil in the engine. Be certain to service engine with gasoline and oil as instructed in the accompanying engine manual before operating your machine.
NOTE: Reference to right or left side of the equipment is observed from the operating position, unless otherwise stated.
Chipper Chute 
Flat
Washers
Support
Bracket
Hex Bolts
Flange
Nuts
Figure 3
•Before starting assembly, disconnect the spark plug wire from the spark plug on the chipper shredder vacuum and ground against the engine.
•Remove the two flange nuts, hex bolts and saddle washers which secure the right side of the upper handle to the right side of the lower handle.
See Figure 4.
5
