Tires
WARNING! Never exceed the maximum inflation pressure shown on the sidewall of the tire.
The recommended operating tire pressure is:
•Approximately 10 psi for the rear tires
•Approximately 14 psi for the front tires
IMPORTANT: Refer to the tire sidewall for exact tire manufacturer’s recommended or maximum psi. Do not overinflate. Uneven tire pressure could cause the cutting deck to mow unevenly.
Battery
California Proposition 65 WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling.
caution: If removing the battery, disconnect the NEGATIVE (Black) wire from it’s terminal first, followed by the POSITIVE (Red) wire. When reinstalling the battery, always connect the POSITIVE (Red) wire its terminal first, followed by the NEGATIVE (Black) wire.
Jump StartingWARNING! Never jump start a damaged or frozen battery. Be certain the vehicles do not touch, and ignitions are off. Do not allow cable clamps to touch.
1.Connect positive (+) cable to positive post (+) of your tractor’s discharged battery.
2.Connect the other end of the cable to the (positive +) post of the jumper battery.
3.Connect the second cable (negative
4.Make the final connection on the engine block of the tractor, away from the battery. Attach to a unpainted part to assure a good connection.
caution: If the jumper battery is installed on a vehicle (i.e. car, truck), do NOT start the vehicle’s engine when jump starting your tractor.
5.Start the tractor as instructed in the Operation section of this manual.
6.Set the tractor’s parking brake before removing the jumper cables, in reverse order of connection.
7.
WARNING! Batteries give off an explosive gas while charging. Charge the battery in a well ventilated area and keep away from an open flame or pilot light as on a water heater, space heater, furnace, clothes dryer or other gas appliances.
caution: When charging your tractor’s battery, use only a charger designed for 12V
If your tractor has not been put into use for an extended period of time, charge the battery as follows:
1.Set your battery charger to deliver a max of 10 amperes.
If your battery charger is automatic, charge the battery until the charger indicates that charging is complete. If the charger is not automatic, charge for no fewer than eight hours.
Fuse
One 20 AMP fuse is installed in your tractor’s wiring harness to protect the tractor’s electrical system from damage caused by excessive amperage.
If the electrical system does not function, or your tractor’s engine will not crank, first check to be certain that the fuse has not blown. It can be found at the rear of the unit, underneath the fender located by the battery.
WARNING! Always use a fuse with the same amperage capacity for replacement.
Cutting Blades
WARNING! Shut the engine off and remove ignition key before removing the cutting blade(s) for sharpening or replacement. Protect your hands by using heavy gloves when grasping the blade.
WARNING! Periodically inspect the blade spindles for cracks or damage, especially if you strike a foreign object. Replace immediately if damaged.
The blades may be removed as follows.
1.Remove the deck from beneath the tractor, (refer to Cutting Deck Removal earlier in this section) then gently flip the deck over to expose its underside.
2.Place a block of wood between the center deck housing baffle and the cutting blade to act as a stabilizer. See Fig.
3.Remove the hex flange nut that secures the blade to the spindle assembly. See Fig.
Section 7 — Service |
| 21 |
| ||
|
|
|