MAINTENANCE AND REPAIR INSTRUCTIONS

Trimming Line

Eyelet

Line Loading Hole

Fig. 42

5.Insert the line into the locking hole (Fig. 43). Do not push the line more than a 1/2 inch (12.7 mm) into the line locking hole. The line will form a small loop (Fig. 43) when it is inserted correctly.

Line Locking Hole

Fig. 43

6.Pull the line from the outer spool until the line is tight against the inner reel (Fig. 44).

Fig. 44

7.Repeat procedures 4-6 with the second piece of line.

8.Hold the outer spool. Wind the inner reel counterclockwise until approximately four (4) inches (102 mm) of line remain (Fig. 45).

NOTE: Do not wind the inner reel before installing the second piece of line.

Fig. 45

9.If winding the line becomes difficult or if the line jams, pull the ends of the line from the spool (Fig. 46). Continue winding the inner reel counterclockwise until approximately 6 inches of line is left.

Fig. 46

INSTALLING A PRE-WOUND REEL

1.Turn the bump knob counterclockwise and remove the bump knob, spring and foam seal (Fig. 47).

Bump Knob

Foam Seal

Spring

Inner Reel

Fig. 47

2.Pull the old inner reel with existing line from the outer spool.

3.Insert the ends of the prewound inner reel line into the outer spool eyelets (Fig. 48). Push the new inner reel, arrow side up, into the outer spool.

14