Quick Start Guide

TCS series

4.Loosen the two wing nuts securing the hf driver retaining brace and lift out the horn and compression driver assembly (fig 4).

5.If required for servicing or replacement, disconnect the cables from the compression driver, making a note of the polarity for later reconnection (fig 5).

6.Rotate the horn to achieve the desired coverage pattern and replace it in the cabinet (fig 6).

7.If the compression driver has been removed, reconnect the cables observing the correct polarity (white cable to the +ve terminal, green/white cable to the –ve terminal) (fig 5).

8.Replace the horn and driver in the cabinet, making sure that the cable passes underneath the driver retainer and the compression driver locates squarely in the retaining brace (fig 6).

9.Tighten the wing nuts.

10.Replace the horn fixing screws and tighten.

11.Reconnect the bass driver, observing the correct polarity (brown cable to the red +ve terminal, blue cable to the black –ve terminal) and reinstate the driver in the cabinet (fig 3). Replace and tighten the driver fixing screws (fig 2).

12.Replace the grille (fig 1) and phase check the cabinet before use.

TCS Quickstart Guide - Page - 6

Page 6
Image 6
Turbosound TCS-61/106, TCS-1561/74(DP), TCS-122/XX(DP), TCS-B15A(DP), TCS-152/XX(DP), TCS-B15B(DP), TCS-B218(DP) TCS series