Turbosound TL-1501, TL-1201, TL-1800 MOUNTING AND FIXING Rigging hardware, TL series, user manual

user manual

TL series

MOUNTING AND FIXING

Rigging hardware

A versatile range of mounting hardware is available that allows enclosures to be used in a variety of ways, in either mobile sound reinforcement applications or permanent installations.

A pole mount / tripod stand fitting is fitted to the bottom of the TL-1201 and TL-1501 full range cabinets. Use this pole mount facility with either optional Turbosound PA-100 35mm diameter poles, or conventional loudspeaker tripod stands. Doing so will raise the TL-1201 or TL-1501 loudspeaker above the heads of an audience, providing better sound coverage from a single enclosure. A matching pole mount socket is provided on the top of the TL-1500,TL-1550 and TL-1800 low frequency enclosures to accept the PA-100 pole.

All TL series cabinets, including low frequency enclosures, can be rigged in permanent installations using optional M10 shoulder eyebolts. The top of the cabinet is provided with two internal threaded rigging points, and a further rigging point is provided on the back panel, below the connector plate, used to determine the amount of downward angle. As supplied, these rigging points are fitted externally with M10 countersunk bolts. To facilitate rigging of the enclosure simply remove these M10 bolts and replace them with M10 x 18mm shoulder eyebolts using a suitable thread locking compound to avoid the possibility of loosening (please refer to Appendix

C:Use of thread locking compounds at the back of this manual). Note: Eyebolts must have a thread length of at least 18mm (3/4”).

TL series manual page 11