DCM150, Ethernet Input Output Controller, Overview

DCM150

Ethernet Input Output Controller

OVERVIEW

The DCM 150 (Door Control Module) is a low cost, two-door controller designed to interface third-party read heads with the CEM range of access control systems.

Acting as a wiring concentrator for up to two doors it allows local door furniture and read heads to be wired to a single point near the door and remotely connected, via CAT5 or Belden 8723 cable, to a CEM intelligent controller such as webEntry™ or a S9000 type controller for use on AC2000 SE. Up to sixteen units can be multi-dropped from a single RS485 Communications line up to a distance of 1,200 Metres from the host controller.

The DCM 150 supports most third-party access control read heads conforming to the physical Wiegand/Mag Stripe (data/data, clock/data) interfaces covering a range of technologies from RF Proximity to Biometric devices. Customised solutions are also available using two high speed serial RS485/RS232 interfaces to support non-standard devices such as biometric, read/write smartcards and crypto modules.

The DCM 150 supports two door configurations. It can either be configured for two read heads on two separate doors, with optional Exit push buttons, or can be configured to support an Entry/Exit configuration for bi-directional control on a single door.

DCM 150

FEATURES

•Support for two doors

•Interfaces third party read heads to CEM intelligent controllers

•Reader communications via standard Wiegand or Mag Stripe interfaces

•Eight Supervised inputs

(four available per door)

•Two Relays (normally opened or normally closed)

•Self resetting fuses – saves maintenance time

•Onboard LED - provides visual status

•Dedicated Tamper input

Tyco DCM 150 manual DCM150, Ethernet Input Output Controller, Overview, Features

Models: DCM 150