
Power Over Ethernet Access Control
DIU 220 incorporates a High power PoE splitter module, delivering sufficient power and Ethernet communication to reliably power a complete door set (consisting of In and Out readers 650mA Maglock, door holder, sounder and strobe) using one CAT 5/6 Ethernet cable.
Benefits
The DIU 220 offers a complete IP based access control solution. Eradicating the need to provide local mains power and AC/DC power supplies at the door, the DIU 220 installation is classed as low voltage and can be completed by IT network installers without the expense of an electrician or electrical contractor.
Low cost exit solution
The DIU 220 incorporates a weigand interface which allows a 3rd party weigand read head to be directly connected. This provides a low cost alternative if an LCD and keypad are not required for the exit side of the door.
CEM/B/047 Rev B
Product Highlights
DIUDIU2220
† see dislosure below
TECHNICAL SPECIFICATIONS
Physical
Size |
| 160 x 160 x 90 mm |
|
| (6.3 x 6.3 x 3.5in) |
Weight | 0.75Kg | |
Housing | Flame retardant polycarbonate | |
Colour | Light grey with transparent lid | |
Power | From High power midspan device | |
|
| (PowerDsine Midspan) |
Environmental |
| |
- | Temperature | up to 50ºC (up to 122ºF) |
- | Humidity | 95% non condensing |
LED Indicators | +12 Volts OK, Lock supply OK, Lock Status, | |
|
| Watchdog, Fault, Battery Low, RS485 Rx |
|
| and TX. |
Functionality |
| |
Inputs | * Door Position | |
|
| * Lock Status |
|
| * Exit Push Button |
|
| * General Purpose |
|
| * = 4 state tamper protected inputs |
Outputs | Three 11.5V open collector outputs limited |
| to 1.5A (Door Lock, Door Holder and |
| External Sounder) |
Reader Output | 11.5V, limited to 800mA |
Memory | 32kB Flash memory |
Communication Interface | |
To Card Reader | Ethernet and RS485 cable |
- Connection | RJ45 and 2 part screw terminals |
PRODUCT CODE |
|
DIU/700/220 | DIU 220 (Complete with PoE backplane |
| and enclosure) |
Product specifications and availability is subject to change without notice. Certain product names mentioned herein may be trade names and/or registered trademarks of their companies.
† Diagrams shown are for illustrative purposes only. Refer to product manual for recommended cabling.
CEM Systems Ltd Unit 4 Ravenhill Business Park Ravenhill Road Belfast BT6 8AW Northern Ireland | www.cemsys.com |
Tel: +44 (0)28 9045 6767 Fax: +44 (0)28 9045 4535 email: cem.sales@tycoint.com |