Light Bulb Replacement
To replace the light bulb in your
2 |
1 |
ULIN_0001_A |
Figure 14
1.Grasp the edges of the light housing lens
(Figure 14, 1) opposite the exposed tab and gently push the lens toward the tab (Figure 14, 2).
2.Pull the edge of the lens down (Figure 14, 1) and swing it out of the light housing.
IMPORTANT
ALWAYS use a genuine
3.Replace the bulb only with a genuine
4.Replace the lens by first inserting the tab side back into the housing at a slight angle. While gently pushing the lens towards the tab end, push the free end up into the housing, and release when you will hear a snap/click.
Disabling the Cascade Feature
To disable the cascade components in the drawers:
ULIN_0244_A |
Figure 15
1.Open the drawer fully.
2.Push the upper rack back to the closed position.
3.Using a Phillips screwdriver, remove the two screws that attach the cascade assembly to the drawer slide.
4.Repeat Step 3 on other side of drawer to disable cascade completely. There are two of these assemblies on each drawer.
5. Repeat Steps
NOTE: Retain these assemblies if you wish to activate your cascade action again.
Wine Rack Removal/Installation
To remove the wine racks:
1.Grasp the end of the wine rack, and gently slide it out until it stops.
2.Remove any bottles stored on the rack.
ULIN_0009_A |
Figure 16
3.Raise the end of the rack to allow the rear rollers to clear the cabinet tracks (Figure 16), and pull the rack from the cabinet.
IMPORTANT
Do not remove the two racks attached at the drawer slides.
To insert the wine racks:
1.Position the wine rack above the cabinet channels where the rack is to be inserted.
2.Slide the rack into the cabinet at an angle until the rack rollers engage the channel (Figure 16) on both sides.
3.Lower the free end of the rack, and slide into the cabinet completely.
2175DWRWC | 15 |
