User’s Manual

DOOR ADJUSTMENT

Your door is aligned at the factory before shipment. Occasional re-adjustment may be necessary, especially if an Overlay Panel is installed. The following procedure will correct for up to 1/4" alignment.

The door should never be flush with the top of the cabinet. Even when level, the top edge of the door will be 1/8" below the top of the cabinet (Figure 17).

To adjust :

1.Compare the top edge of 1/8" the door (opposite the

hinges) to the top edge of the cabinet and note the type (up or down) of adjustment needed.

2. Remove the top hinge

 

pivot pin with a 7/64" hex

DOOR001

wrench (Figure 18) and lift

 

door off bottom hinge pin.

 

Figure 17

Be careful not to lose door

closers (Figure 20).

 

 

3.With door upside-down, loosen but do not remove the two hinge plate screws.

UL310

Figure 18

18