3.Remove 12 screws and back panel.

4.Check that the clamps and hose connections are tight at the fol- lowing areas:

•Discharge tube (A)

•Drain tube (B)

•Vent tube (C)

B B

C

A

BACK VIEW

SIDE VIEW

 

UL184-2

5.Place a suitable container beneath the pump’s discharge tube. (The bucket must be able to hold a minimum of one gallon.)

!WARNING

Back panel serves as a guard. DO NOT put your hands inside the ice maker cabinet or attempt to touch any components except the discharge tube during testing. Failure to follow this warning could result in serious personal injury or death.

6.Plug the ice maker power cord into a properly grounded, polarized electrical outlet.

7.Verify pump operation by pouring one gallon of water into the ice storage bin of the ice maker. The pump should energize and pump the water into the container.

8.At this time, verify that all tube and clamp connections are tight and leak free.

9.Unplug unit power cord from electrical outlet.

10.Leave back panel off for water supply line installation.

11.Continue to the next step in the installation process, SITE PREPARATION.

7