User’s Manual
The ice cube thickness control is factory set for best overall perfor- mance. The factory setting is designed to maintain an ice bridge of approximately 1/16" to 1/8" under normal conditions resulting in a dimple of approximately 1/4" to 1/2" in depth (Figure 30). A fuller cube with less of a dimple results in a thicker ice bridge. As the ice bridge becomes thicker, the tendency for the cubes to stay together as a slab increases. A bridge thicker than 1/8" may cause cubes to overfill the ice bucket.
|
|
|
|
|
|
|
|
|
|
| BRIDGE |
| BRIDGE | |
1/4" TO 1/2" |
| 1/16" TO 1/8" |
| TOO THIN |
| TOO THICK | ||||||||
| DIMPLE |
| LITTLE OR | |||||||||||
DIMPLE |
| ICE BRIDGE |
| |||||||||||
| TOO DEEP |
| NO DIMPLE | |||||||||||
|
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
GOOD | BAD |
ICE002
Figure 30
To adjust:
!WARNING
Disconnect power to the ice maker before making any ice thickness adjustments.
1.Disconnect power to the unit.
ACCESS
PANEL
SCREWS
WARMER
SET
TEMP
COLDER
CLRCO030
Figure 31
26