U-Line CO2175FF 2175RF manual Leveling, Ice Cube Thickness Adjustment Interval As Required

Ice Cube Thickness Adjustment

Interval - As Required

On ice maker equipped models, the cube size may be adjusted by changing the amount of water injected into the ice maker assembly as follows:

ULIN_0273_A

Figure 11

1. Remove the ice maker assembly cover (Figure 11).

ULIN_0056_A

Figure 12

2.Locate the adjusting screw on the ice maker assembly control box. The adjusting screw is just below the minus (-) and plus (+) signs on the control box (Figure 12).

NOTE: Make adjustments in small increments. Too large of an adjustment could cause the unit to malfunction.

CAUTION

Too large of an adjustment to the screw can cause the water to overflow the ice maker and can cause property damage.

3.Turn the adjusting screw toward the minus (-) sign (clockwise) for smaller cubes or toward the plus (+) sign (counterclockwise) for larger cubes.

4. Install the ice maker assembly cover.

IMPORTANT

Use only genuine U-Line replacement parts. U-Line ice maker parts are not the same as standard FSP Whirlpool parts. Using non U-Line parts can reduce ice rate, cause water to overflow from ice maker mold, damage the unit, and may void the warranty.

Leveling

It is important that units equipped with adjustable feet are level, for proper door and ice maker (if equipped) operation.

To level units with adjustable feet:

1

ULIN_0193_A

Figure 13

1.Use a level to check the levelness of the unit from front to back and from side to side. Level should be placed along top edge and side edge as shown (Figure 13).

1

ULIN_0042_A

Figure 14

2.If the unit is not level, adjust the feet on the corners of the unit as necessary (Figure 14).

3.Check the levelness after each adjustment and repeat the previous steps until the unit is level.

CO2175FF, 2175RF 13