7.Connect the USB connector end of the Barcode Scanner cable to a USB port on the back of the PC. Connect the other end into the jack on the barcode scanner handle.

Figure 5: Rear View of PC, Scanner connection

8.Connect the optional MSR (Magnetic Stripe Reader) assembly to the 1800 Series unit as follows:

Figure 6: Back View of 1800 Unit and MSR Assembly

1. Connect the USB cable

Main Unit

Insert the USB connector into the USB port at the side of the main unit.

2. Position the MSR

USB Port

To MSR Unit

MSR Unit

Align the MSR unit with the guide rails on the main unit and slide it into position, making sure the entire USB cable is covered by the MSR housing.

3. Insert and tighten screws

Insert the two screws provided with the MSR

 

USB

unit, and tighten to secure the MSR housing

Insert screws

to the main unit.

 

 

 

 

 

© 2008 UTC RETAIL. All rights reserved.

11692014 Rev C

Page 7 of 12