Operating Procedure
1.The fog machine must be connected to a grounded supply of at least 15 amps free of any interference.
2.Open a 20 Litre (5 Gallon) container of Ultratec Special Effects fog fluid and insert the fluid pickup tube into the spout of the fluid container.
3.Connect the Remote Handset into the rear panel connector located on the rear panel. (When using DMX the Remote is not required).
4.Activate the Power switch located on the rear panel. The Power switch and Handset indicator will illuminate to indicate the presence of power. If the Handset indicator does not illuminate, ensure the connector is properly inserted.
5.The Handset indicator will begin to flash slowly, but will speed up when the fog machine is ready to operate. After approximately 9 minutes, the fog machine will be fully heated and is ready for full output; the indicator will be on solid.
6.It may be necessary to prime fluid into the system to expel any air. The Variflow control on the remote handset should be set to the full position. A dry hose can take between
7.To adjust the depth of the hose, simply loosen Nut ‘A’ and slide up or down the hose and retighten. Be careful not to pinch off the flow of fluid.
NOTE: In order to prime the fog machine, the Handset Indicator must be a solid red.
Operating Procedure w/ Air Option
A)Mount the Regulator Bracket to a wall or other secure location.
B)Attach the female coupler to the male coupler of the
Power Fog Industrial w/ Air Option or Power Fog Industrial 9D w/ Air Option.
C)Attach the air hose to the male coupler of the mounted regulator.
D)Adjust for the desired air pressure (typically
A D A B
C
A
A
www.ultratecfx.com 7
