Uniden DCT5285 manual Chain Dialing, Memory Dialing base only, Storing Phone Numbers

•The 10 memory locations in the base are independent from the handset.

•If you have not pressed any key for 30 seconds, the phone returns to the standby mode.

•If you make or receive a call, the operation is canceled.

Chain Dialing

The memory locations in the handset are not limited to phone numbers. You can also store a group of numbers (up to 20 digits), that you need to enter once your call connects. This is referred to as Chain Dialing.

An example of this is a bank account number. Store a special number in the phonebook location (refer to “Storing Phone Numbers, Names, Distinctive Rings and Speed Dial” on page 37). Once you have called your bank, and when you are prompted to enter the account number, just as you do when viewing the phonebook location, view the special number, then press the DIAL soft key.

Memory Dialing (base only)

You can store 10 phone numbers in the base, and make calls with memory dialing from the base.

Storing Phone Numbers

1)Press memory in the standby mode.

2)Enter the number you wish to store. (The number cannot exceed 20 digits.)

3)Press memory. Enter the memory location number (0-9) on the keypad. You will hear a confirmation tone.

Making Calls with Memory Dialing

1)Press (talk) in the standby mode.

2)Press memory. Enter the memory location number (0-9) to dial the number.

Deleting the Stored Data

1)Press memory in the standby mode.

2)Press memory again.

3)Enter the memory location number (0-9) you wish to delete. You will hear a confirmation tone.

[ 44 ] P H O N E B O O K