Uniden DCT5285 manual Remote access with the handset

Command	Function
0 then 1	Repeat a Message*
0 then 2	Playing incoming Messages
0 then 3	Skipping a Message
0 then 4	Deleting a Message
0 then 5	Stop Operation

Command	Function
0 then 6	Answering System On
0 then 7	Memo Record/Stop **
0 then 8	Greeting Message Record/Stop **
0 then 9	Answer System Off
1 then 0	Help Guidance

*For Repeat a Message function, press 0 then 1 within about four seconds to repeat the previous message, or press 0 then 1 after about four seconds to repeat the current message.

**For Memo Record and Greeting Message Record function, the first time you enter the corresponding command, it starts the Recording function. If you want to stop the recording, press 0 then 7 or 8.

5)After the command has finished, you hear intermittent beeps indicating that the system is in the command waiting mode. You may enter another command at this time from the chart above.

6)When you are finished, hang up to exit the system. The answering system automatically returns to standby.

Remote access with the handset

You can check your new incoming messages, skip, repeat, or delete your incoming messages with the handset. For example, you can install the answering system in the living room, and check your incoming message from a bedroom with the handset.

You can also use speakerphone on the handset for remote operation (see “Making and receiving calls” on page 31).

•If you press end before the answering system answers, the phone will return to standby.

•When the answering system does not answer within 6 seconds, you hear a beep and the phone will return to standby.

• The base’s keypad is disabled during remote operation.

•When you receive a call, the remote operation is canceled.

•You can change the handset volume during a remote operation.

•During the remote operation “ ” appears on the base.

[ 62 ] T H E I N T E G R AT E D A N S W E R I N G D E V I C E