Uniden DS71 manual No power on

PROBLEM	SUGGESTION
	● Check the telephone line cord connectors at both ends
	that they are pushed in firmly until they click.
No dial tone.	● If you had a power failure or had unplugged the base
	unit, replace the handset on the base unit for two to five
	second to reset the system.
	● You may have exceeded the Ringer Equivalence Number
	(REN) limit of how many phones can be connected to the
Does not ring.	same line. The REN total of all devices (printed on the
	label on the bottom of each unit) should not exceed three
	(3). Disconnect the appropriate units to lower the REN
	total.
	● Check the Ni-MH battery pack connection inside the main
No power on	battery compartment on the handset.
handset unit	● The handset rechargeable Ni-MH battery pack may need
	to be charged.
	● Make sure the charging contacts on both the base unit
	and the handset are in contact during charging.
Does not charge	● The charging contacts may need to be cleaned. Refer to
	page 4 or page 15.
Calls received	● The Ni-MH battery pack may need to be discharged first	TROUBLESHOOTING
	charging.
	before a full charge.
	● Raise or reposition the antenna on the base or handset.
Range is limited	● Move the base unit so that it is centrally located in your
	residence or office and make sure that the base unit is not
	located near appliances.
	● The handset rechargeable Ni-MH battery pack may need
flutters or fades	● You may be out of normal operating range. Move closer to
	the base unit.
	● When storing phone numbers, make sure that the handset
Cannot store or	is in the standby position.
	● When recalling stored phone numbers, check first for a
recall phone
	dial tone.
numbers from
	● Always use two digits when entering/recalling memory
memory
	index numbers.

25