Uniden DX15686 Series Installing the Belt Clip, Headset Installation, To attach the belt clip

Models: DX15686 Series

1 48
Download 48 pages 54.98 Kb
Page 13
Image 13

Make sure the wall material is capable of supporting the weight of the base and handset.

Use #10 screws (minimum length of 1-3/8 inches) with anchoring devices suitable for the wall

material where the base unit will be placed.

1)Insert two mounting screws into the wall (with their appropriate anchoring device), 3-15/16 inches apart. Allow about 1/8 of an inch between the wall and screw heads for mounting the phone.

2)Refer to steps 1 through 5 on page 11 to mount the telephone.

Installing the Belt Clip

To attach the belt clip

Insert the belt clip into the holes on each side of the handset. Press down until it clicks.

To remove the belt clip

Pull both sides of the belt clip to release the tabs from the holes.

Headset Installation

Your phone may be used with an optional headset. To use this feature, insert the headset plug into the headset jack. Your phone is ready for hands-free conversations. (Headsets may be purchased by visiting our website at www.uniden.com or by calling our Parts Department. See back cover page.)

12

Page 13
Image 13
Uniden DX15686 Series Installing the Belt Clip, Headset Installation, To attach the belt clip, To remove the belt clip