UP033BH_EXI7246C.book Page 10 Wednesday, June 16, 2004 2:14 PM
3) Install the Alkaline batteries into the battery compartment observing the correct polarity. Make sure the outdoor temperature and humidity appear on the base display within five minutes. If the outdoor temperature and humidity don't appear, switch the Channel switch to another channel and remove the batteries. Install the batteries again.
4)Replace the cover and tighten the knob with a screwdriver or a coin.
5) Place the handset in the base unit with the keypad facing forward. Set up the outdoor weather sensor according to page 7.
6) Make sure the charge/in use LED illuminates. If the LED does not illuminate, check to see that the
AC adapter is plugged in and the handset makes good contact with the base charging contacts.
Charge your handset at least
|
| 7) Once the handset battery pack is fully charged, |
|
|
|
| ||
|
| connect the telephone line cord to the TEL LINE |
|
|
|
| ||
|
| jack and a telephone outlet. |
|
|
|
| ||
Modular | ||||||||
|
| If your telephone outlet isn't modular, contact your | ||||||
|
|
|
|
|
| |||
|
| telephone company for assistance. |
|
|
|
| ||
| w w w . u n i d e n . c o m |
|
|
|
| |||
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
!
•Use only the Alkaline batteries supplied with your outdoor weather sensor.
•The base LCD will blink and prompt you to set the time. See "A. Set the Time" on page 14 for the instructions on how to set the time.
•Once the outdoor temperature and humidity appear on the base display, do not change the channel unless you replace the batteries.
•Do not place the power cord where it creates a trip hazard or where it could become chafed and create a fire or electrical hazard.
G E T T I N G S T A R T E D [ 1 0 ]
G E T T I N G S T A R T E D
