Uniden EXAI8580 1) Installing the Phone, 6, 1, 3, 1, 3, 4, 5, 4, 5

Sheet 2
1) Installing the Phone
1-1. Choosing the Best Location
To get the best performance out of your new phone, put it in the best location:
Near an AC outlet
and a telephone
wall jack.
• Microwave ovens
• Refrigerators
• Fluorescent
lighting
• Dust
• Excessive
moisture
• Other cordless
telephones
In a
centrally-located
open area.
PLACE YOUR BASE
• TVs
• Other electronics
• Direct sunlight
• Extreme temperatures
• Personal computers
• Wireless LAN
equipment
• Dust
• Excessive
moisture
• Areas with
a lot of
background
noise
• Shock
• Vibration
• Shock
• Vibration
TRY TO AVOID
Notes: For maximum range
Keep both the base and handset antennas free of obstruction.
When the handset is not in use, place the handset in an upright position.
Metal and reinforced concrete may aect cordless telephone performance.
•
•
•
1-2. Plug in the Battery
Use only the Uniden BT-905 rechargeable battery pack supplied with your phone.
1Locate the battery pack,
battery cover and handset. 2Line up the red and black wires on the battery pack connector
with the sticker in the handset's
battery compartment.
3Place the cover over the
battery compartment and
slide it up into place.
Push the battery connector in firmly.
(You should hear it click into place.)
Red
Black
1Locate the battery pack,
battery cover and handset. 2Line up the red and black wires on the battery pack connector
with the sticker in the handset's
battery compartment.
3Place the cover over the
battery compartment and
slide it up into place.
Push the battery connector in firmly.
(You should hear it click into place.)
Red
Black
1-3. Plug in the Base
Don’t put any power cord where it people might trip over it or step on it. If a power cord becomes chafed or
worn out, it can create a re or electrical hazard.
4Put the base's AC adapter cord through the hole in the stand
and connect the AC adapter to the DC IN 9V jack.
6
5
Connect the AC adapter to a standard 120V AC wall outlet.
DO NOT use an AC outlet controlled by a wall switch.
Route the cord
through the molded
wiring channel.
To AC outlet
AC adapter
(supplied)
To DC IN 9V
4Put the base's AC adapter cord through the hole in the stand
and connect the AC adapter to the DC IN 9V jack.
6
5
Connect the AC adapter to a standard 120V AC wall outlet.
DO NOT use an AC outlet controlled by a wall switch.
Route the cord
through the molded
wiring channel.
To AC outlet
AC adapter
(supplied)
To DC IN 9V