Uniden EXI8560 Connect the Telephone Cord, Now your phone is ready to use Attach the Belt Clip

1-4. Connect the Telephone Cord

8	Connect the telephone cord to the
	TEL LINE jack on the rear of the base.
9	Connect the telephone cord	To TEL LINE
	to a telephone wall jack.

To telephone

wall jack

Telephone cord (supplied)

Note: If the telephone cord does not fit into your telephone wall jack, contact your local phone provider for assistance.

If you receive high-speed internet service through your telephone line (referred to as DSL), you should install a DSL filter between the telephone base and the wall jack. Standard telephones often can’t operate correctly without a DSL filter.

Telephone

wall jack

DSL filter

Telephone cord

Test the connection

10	Pick up the handset from the base and press [TALK/flash].
	You should hear a dial tone, and the display should showTALK.
	Talk	0:01	What if I can't hear a dial tone?
			Check the telephone cord connection on the base.

What if the display doesn't show TALK?

Put the handset back in the base for at least five seconds.

Make sure the /in use LED flashes.

11 Make a quick test call, and then press [END] to hang up.

What if the call doesn't go through?

Try changing the dial mode (see below).

What if there is a lot of static?

Check the sources of interference described in section 1-1 on Choosing the best location: is the base near any of those?

Changing from tone to pulse dialing (DIAL)

Your phone can communicate with the telephone network in two different ways: tone dialing or pulse dialing. These days, most phone networks use a method called tone dialing, so your phone comes programmed for tone dialing.

If your phone company uses pulse dialing, you need to change your phone’s dial settings. If you don't get a dial tone or can't connect to the telephone network, follow the steps below to modify your phone’s settings:

1)With the phone in standby, press and hold [cid/menu].

2)Press [] to move the pointer to DIAL.

3)Press [select/channel] to set the phone to pulse dialing.

4)Press [END] and put the handset back in the base. The handset communicates the new setting to the base.

Note: If you use pulse dialing and you need to send DTMF tones during a call (if you're using an automated response system, for example), press [/tone/] to temporarily switch to tone dialing. When the call ends, the phone automatically returns to pulse dialing mode.

Now your phone is ready to use!

1-5. Attach the Belt Clip

To attach the belt clip

Insert the tabs on the side of the belt clip into the holes on either side of the handset. Press the belt clip down until it clicks into place. (Tug on the clip to make sure it’s secure.)

To remove the belt clip

Gently pull the tabs out of the holes, then slide the belt clip off of the handset.