4) Place the handset on the base.

NOTE: Use only the Uniden Battery (BT-905) supplied with your phone. Replacement batteries are also available through the Uniden Parts Department.

Battery use time (per charge)

From fully charged

Seven hours continuous use

Fourteen days when the handset is in the standby mode

Low Battery Alert

When the battery pack is very low and needs to be charged, the phone is programmed to eliminate functions in order to save power. If the phone is not in use, the talk/batt LED flashes when the battery pack is low.

If the phone is in use, the talk/batt LED flashes and the handset beeps. Complete your conversation as quickly as possible and return the handset to the base for charging.

NOTE: The last number dialed in the redial memory and the numbers stored in the memory locations are retained for up to 1 minute while you replace the battery pack.

Cleaning the Battery Charging Contacts

To maintain a good charge, it is important to clean the battery contacts on the handset and base unit with a dry cloth or a pencil eraser about once a month.

Do not use any liquids or solvents.

NOTES: Even when the battery pack is not being used, it will gradually discharge over a long period of time. For optimum performance, be sure to return the handset to the base unit after each telephone call.

If you must replace the battery pack during a telephone call, complete the replacement within 30 seconds, and you can return to the original call.

C.Connect the base unit

1) Connect the AC adapter to the DC IN 9V jack and a standard 120V AC wall outlet.

2) Set the base unit on a desk or tabletop, and place the handset on the base unit as shown.

3) Then raise the antenna to a vertical position.

4) Make sure the status LED lights. If the LED does not light, check to see that the AC adapter is plugged in and the handset makes good contact with the base charging contacts.

NOTICE: Place the power cord so it does not create a trip hazard or where it could become chafed and create a fire or electrical hazard.

NOTES: Use only the supplied AD-310 AC adapter. Do not use any other

AC adapter.

Connect the AC adapter to a continuous power supply.

Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.

The handset can be placed face up or face down in the base for charging.

2

Page 3
Image 3
Uniden EXP2800 manual Connect the base unit, Battery use time per charge