Automatic Power Save Feature
Your
If there is no transmission nor an incoming call within 3 seconds, your radio switches to the Power Save mode. The radio is still able to receive transmissions in this mode.
LCD Backlight
The LCD backlight will automatically turn ON when any key (except for the PTT and Power boost button) is pressed. The LCD display will illuminate for 10 seconds before turning OFF.
Monitor Mode Feature
Your
To turn ON the monitor mode:
•Press mon for brief listening, the 
icon will blink.
•Press and hold mon for 2 seconds for continuous listening. The receiver circuit will stay open, and letting in both the noise & weak signals.
To turn OFF monitor mode:
•Press mon to return to "Normal" mode, and the
icon stops blinking.
Roger Beep
Roger Beep is a BEEP that is sent to notify the end of transmission (PTT transmission, power boost transmission and VOX.) Roger Beep can be heard through the speaker when Key Beep is on. If key beep is turned off, Roger Beep will not be heard from the speaker.
To turn ON Roger Beep:
Press and hold the ▲ key while turning ON the radio.
To turn OFF Roger Beep:
Press and hold the ▲ key while turning ON the radio.
SPECIFICATIONS
Channels | 15 GMRS / 7 FRS |
Operating Frequency | UHF 462.5500- |
| 467.7125 MHz |
Power Source | 4 AAA Alkaline Batteries or |
| NiMH Battery Pack |
Range | Channels |
| Channels |
| 6 miles |
| (10 miles with Power boost button) |
Battery Life | 22 Hours typ. - |
| Alkaline Batteries |
| (5/5/90 duty cycle) |
| 15 Hours typ. - NiMH |
| Battery Pack |
Frequency Chart |
|
| ||
Ch. Freq. | Cross | TX Power | TX Power | |
No. (MHz) | Reference | (ptt/vox) | (Boost) | |
1 | 462.5625 | FRS & GMRS 1 | Mid | High |
2 | 462.5875 | FRS & GMRS 2 | Mid | High |
3 | 462.6125 | FRS & GMRS 3 | Mid | High |
4 | 462.6375 | FRS & GMRS 4 | Mid | High |
5 | 462.6625 | FRS & GMRS 5 | Mid | High |
6 | 462.6875 | FRS & GMRS 6 | Mid | High |
7 | 462.7125 | FRS & GMRS 7 | Mid | High |
8 | 467.5625 | FRS8 | Low | Low |
9 | 467.5875 | FRS9 | Low | Low |
10 | 467.6125 | FRS10 | Low | Low |
11 | 467.6375 | FRS11 | Low | Low |
12 | 467.6625 | FRS12 | Low | Low |
13 | 467.6875 | FRS13 | Low | Low |
14 | 467.7125 | FRS14 | Low | Low |
15 | 462.5500 | GMRS11 | Mid | High |
16 | 462.5750 | GMRS8 | Mid | High |
17 | 462.6000 | GMRS12 | Mid | High |
18 | 462.6250 | GMRS9 | Mid | High |
19 | 462.6500 | GMRS13 | Mid | High |
20 | 462.6750 | GMRS10 | Mid | High |
21 | 462.7000 | GMRS14 | Mid | High |
22 | 462.7250 | GMRS15 | Mid | High |
REGULATORY INFORMATION
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that may cause undesired operation.
Important: Changes or modifications to this unit not expressly approved by Uniden could void your authority to operate this unit. Your radio is set up to transmit a regulated signal on an assigned frequency. It is against the law to alter or adjust the settings inside the radio to exceed those limitations. Any adjustments to your radio must be made by qualified technicians.
To be safe and sure:
• Never open your radio’s case.
• Never change or replace anything in your radio except the batteries.
Your radio might cause TV or radio interference even when it is operating properly. To determine whether your radio is causing the interference, turn it off. If the interference goes away, your radio is causing it. Try to eliminate the interference by moving your radio away from the receiver. If you cannot eliminate the interference, the FCC requires that you stop using the radio.
Hazardous Environments: Do not operate the radio in hazardous environments. Explosion or fire may result. Do not operate the radio near unshielded electrical blasting caps.
Under certain conditions, radios can interfere with blasting operations and may cause an explosion. Turn your radio OFF to prevent accidental transmission when in a blasting area or in areas posted: "Turn off
Care and Safety: To clean the radio, use a soft cloth dampened with water. Do not use cleaners or solvents because they can harm the body of the unit and leak inside, causing permanent damage. Use a dry,
Dry the battery compartment with a soft cloth to minimize potential water damage. Leave the battery compartment cover off overnight to ensure complete drying. Do not use the radio until the unit is completely dry.
RF EXPOSURE INFORMATION
WARNING! Read this information before using the radio In August 1996 the Federal Communications Commission (FCC) of the United States with its action in Report and Order FCC
Those guidelines are consistent with the safety standard previously set by both U.S. and international standards bodies. The design of the radio complies with the FCC guidelines and these international standards.
Never allow children to operate the radio without adult supervision and the knowledge of the following guidelines.
WARNING! It is up to the user to properly operate this radio transmitter to insure safe operation. Please adhere to the following:
Use only the supplied or an approved antenna. Unauthorized antennas, modifications, or attachments could impair call quality, damage the radio, or result in violation of FCC regulations. Do not use the radio with a damaged
antenna. If a damaged antenna comes into contact with the skin, a minor burn may result. Please contact your local dealer for a replacement antenna.
Body-worn Operation
This device was tested for typical
To maintain compliance with FCC RF exposure requirements,
For hand-held operation, the radio should be held
1 inch from the user's face. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements and should be avoided.
For more information about RF exposure, please visit the FCC web site at www.fcc.gov.
ONE YEAR LIMITED WARRANTY
Important: Evidence of original purchase is required for warranty service.
WARRANTOR: UNIDEN AMERICA CORPORATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this Uniden Product to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below.
WARRANTY DURATION: This warranty to the original user shall terminate and be of no further effect 12 months after the date of original retail sale. The warranty is invalid if the Product is:
(A)damaged or not maintained as reasonable or necessary, (B) modified, altered, or used as part of any conversion kits,
(E)used in any conjunction with equipment or parts or as part of any system not manufactured by Uniden, or (F) installed or programmed by anyone other than as detailed by the owner’s manual for this product.
STATEMENT OF REMEDY: In the event that the product does not conform to this warranty at any time while this warranty is in effect, warrantor will either, at its option, repair or replace the defective unit and return it to you without charge for parts, service, or any other cost (except shipping and handling) incurred by warrantor or its representatives in connection with the performance of this warranty. Warrantor, at its option, may replace the unit with a new or refurbished unit.
THE LIMITED WARRANTY SET FORTH ABOVE IS THE SOLE AND ENTIRE WARRANTY PERTAINING TO THE PRODUCT AND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY OPERATION OF LAW, INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OVERPAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This warranty
is void outside the United States of America and Canada.
PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the owner’s manual you are certain that the Product is defective, pack the Product carefully (preferably in its original packaging). The Product should include all parts and accessories originally packaged with the Product. Include evidence of original purchase and a note describing the defect that has caused you to return it.The Product should be shipped freight prepaid, by traceable means, to warrantor:
Uniden America Corporation
Parts and Service Division
4700 Amon Carter Blvd., Fort Worth, TX 76155
(800)
www.uniden.com
Covered under one or more of the following U.S. patents:
4,684,870 4,734,049 5,203,015 5,214,789
5,491,745 5,497,508 5,517,677 5,557,606
5,574,994 5,610,946 5,613,201 5,625,870
5,627,876 5,628,059 5,634,196 5,634,205
5,678,176 5,697,096 5,717,312 5,722,070
5,787,345 5,901,341 6,021,326 6,084,861
6,163,691 6,195,415 6,353,730
© 2005 Uniden America Corporation All rights reserved Printed in China UTZZ01006ZA
