9.NB/ANL SWITCH - You can select either Noise Blanker and Automatic Noise Limiter, only Automatic Noise limiter or all filters OFF. The NB and ANL help to
reduce harsh background noise caused by a variety of interference sources. The ANL will not work in the USBor LSBmode.
10.PA SWITCH- Movethis switch to the Public Address mode when an external PA speaker is connected. When the PA mode is selected, you can use the PA function
and yet can monitor CB incoming signals. Adjust the PA output levelby rotating the volume control.
11.AM/SSB SELECTOR - The three position switch allows you to select AM (standard 40 channel CB) or USB (Upper Side Band) or LSB (Lower Side Band) operation.
12.CLARIFIER - Turn this control to achievethe best tuning of the upper or lower side band receiving frequency.
@@
"
w
@ @
13.ANTENNACONNECTOR- This female connector permits connection of the transmission line cable male connector
14.PUBLIC ADDRESS - An external 8 ohm
15.EXTERNAL SPEAKER - The external speaker jack is used for remote receiver monitoring. The external speaker should have an 8 ohm impedance and be rated at least 4 watts. When an external speaker is connected, the internal speaker is disabled.
16.POWER - This plug permits connection of the DC power to the transceiver. The supplied DC Cord's plug is polarized which ensures that power will always be connected and fused properly.
OPERATING PROCEDURE TO RECEIVE
1.Be sure that the power source, antenna and microphone are properly connected.
2.Turn the unit on by rotating the Volume control clockwise.
3.Set the channel selector switch to the desired channel.
4.Set the Volume control to a comfortable listening level.
5.Listen to the background noise from the speaker. Turn the Squelch control clock- wise until the noise disappears (no signal should be present). Leave the control at
.~
