PRO501 AXLAccessories
To connect the Cigarette LighterAdapter Plug:
IMPORTANT: The CigaretteLighter Adapter Plug is designed to be used ONLY with negative ground vehicles. Do not attempt to operate the unit with the Adapter Plug connected to a positive ground vehicle.
1.Remove the screw from the top half of the plug shell (Be careful not to lose the hex nut).
2.Carefully separate the two halves of the plug shell.
3. | wire end. |
| t | ~ | ||
Strip | 1/5 inch of insulation from each |
|
|
| ||
4. | Crimp the terminals | onto the wire |
| CrImp | on Insulation | |
|
| i" | ||||
| ends | as shown. |
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| Black |
|
|
|
|
|
| Red |
5. | With | the wires attached, insert the |
|
|
| |
| terminals into the plug shell. |
|
|
| ||
| Note | The black | wire is inserted in the |
|
|
|
|
| section of the shell marked |
|
|
| |
negative
shell marked positive (+).
6. Join the two halves of the plug shell. Secure the plug shell with the screw and hex nut.
Attaching the Magnetic MountAntenna
1.Place the antenna in a convenient location on your vehicle.
2.Route the antenna cable through your vehicle's window, door, or other opening into the interior of the vehicle.
3.Attach the antenna cable to the terminal on the rear of the PRO501 AXL.
Note: Be sure to route the antenna where it will not interfere with the operation of your vehicle.
