IN STALtATI ON
",V,;I
Plan the location of the radio and micro-
phone bracket before starting installation. Selecta locationthat is convenient for op- eration and does not interfere with the
driver or passenger in the vehicle. The radio should be securely fastened to a solid surface using the mounting bracket and
although the efficiency is less than a full quarter wave whip antenna.
For marine installation, consult your dealer for information regarding an adequate grounding system and prevention of elec-
trolysis between fittings on the hull and water.
Connecting the Power Cord
Negative Ground System
Ifyou are operating on a negative ground system, connect the red DC power cord from the radio to the positive" + " battery terminal or other convenient point and connect the black power lead, to the chas- sis or vehicle frame, or the negative" - " terminal of the battery.
Positive Ground System
If you are operating on a positive ground system, connect the black DC power cord from the radio to the negative"
Mobile Antenna
Since the maximum allowable power out- put of the transceiver is limited by the
With regard to the connection of the power cords, it may be possible or de- sirable to connect the red lead (for nega'- tive ground systems) or the black lead (for
WARRANTY
TWO YEAR LIMITED WARRANTY
OD.C., thecmtenna is a very important fac- tor affecting transmission distance. It is for this reason that we strongly recommend that you install only a quality antenna in your new CB radio system. You have pur- chased a superior quality transceiver.
Don't diminish its performance by in- stalling an inferior antenna.
Only a properly matched antenna system will allow maximum power transfer from the
ing element. We recommend that you use an SWR meter when installing your an- tenna. Set your PRO S20e to channel 20 and make adjustments to the antenna un-
positive ground systems) to the ignition switch accessory terminal so that the radio is automatically turned off when the ig- nition switch (key) is turned off.
Alternately, the power lead may be con- nected to an available terminal on the fuse
block or even to a point in the wiring harness. Care must be taken, however, to
guard against a short circuit condition. When in doubt, please contact your ve- hicle dealer for specific information about your vehicle.
Ground Information
WARRANTOR.UN/DEN AUSTRALIA PTY. LTD. 345
Princes Highway, Rockdale, N.S. W 2216 ("UNIDEN"). ELEMENTS OF WARRANTY. UNIDEN warrants,for
the duration of this warranty, its UNIDEN CB Product to be free from defects in materials and craftsmanship with only the limitation or exclusions set out below.
WARRANTY DURA TION. This Warranty shall termin-
ate and be of no further effect Two (2) years after the date of original purchase of the Product or at the time
the Product is (a) damaged or not maintained as rea-
sonable and necessary, (b) modified, (c) improperly
installed, (d) is repaired by someone other Warrantor
for a defect or malfunction covered by this Warranty, or (e) used in a manner or purpose for which the Pro-
duct was not intended.
PARTS COVERED. This Warranty covers all compo- nents of the Products.
STA TEMENT OF REMEDY. In the event that the Pro-
duct does not conform to this Warranty at any time while this Warranty is effective, Warrantor will repair
the defect and return it to you prepaid, without charge
for parts, service, or any other costs incurred by
Warrantor or its representatives in connection with the performance of this Warranty. In addition, if the Product contains a defect or malfunction which is not
repaired after a reasonable number of attempts by Warrantor to repair the Product, the Product or defec- tive component will at our discretion, be replaced
without charge, when the defective product is
ered to the warrantor at 345 Princes Highway, Rock- dale, N.S. W 2216 free and clear of all liens and en-
cumbrances. Please note that while the Product will
be remedied under this Warranty without charge.
THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THEREIMBURSEMENT OR PA YMENT OF INCID- ENTAL OR CONSEQUENTIAL DAMAGES.
PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY. In the event that the Product does not
conform to this Warranty, the Product should be shipped prepaid, to Warrantor at 345 Princes High-
way, Rockdale, N.S. W 2216. THEORIGINAL OR COpy
OF THESALES RECEIPT OR OTHER VALID EVIDENCE OF THE DA TE OF THE ORIGINAL PURCHASE MUST ACCOMPANY THIS PRODUCT.
til the meter reads as close to 1 as possible. Your Uniden dealer is qualified to assist you in the selection of the proper antenna to meet your application requirements.
For automobile installation, the whip antenna may be used with good effect. The most efficient and practical installa- tion is a full quarter wave whip antenna mounted on the rear deck or,fender top, midway between the rear window and bumper.
Mostnewer cars andsmall trucks usea ne-
gative ground system, while some older cars and some newer larger trucks may use a positive ground system. A negative ground system is generally identified by the
NOTE: This radio may be installed and
uniden@
Australia Pry. Ltd.
|
|
| HEAD | OFFICE: | |
| 345 Princes Highway, Rockda/e, NSW. 2216 | ||||
|
|
| Phone: | 599 | 3355 |
|
|
| Fax: /02) | 599 | 7657 |
BRISBANE |
|
| PERTH | ||
3/12 | Randall | Street, |
| 23 Geddes Street, | |
Slacks Creek, |
|
| Balcatta, | ||
Old, | 4127 |
|
| WA 6021 | |
Phone | /07) |
| Phone (09) | ||
Fax /07) 808 | 4251 |
| Fax /09) 3498165 | ||
MELBOURNE & TASMANIA | ADELAIDE | ||||
Bell Street, |
| 72- 74 Halifax Street, | |||
East | Preston, |
|
| Adelaide | |
A short "loaded" whip antenna is more used in any 12~voltDC negative or posi- convenient to installon your automobile, tive ground system.
VIe. 3072 | SA 5000 |
Phone /03) | Phone /08) |
Fax /03) 484 6057 | Fax (08) 223 1471 |
UTUAO I 3 I 7CB/SK)
@ Copyright J989 Uniden Corporation | Printed in the Philippines |
