Controls & Indicators | Uniden UH-048XR specs

CONTROLS & INDICATORS

3

4

1

5

2

			9
	6
	7	Function	10
	7		11
	8		11
	8	Monitor	12
		Monitor	12

Power/Enter

13

UH048

25

Image 28

Uniden UH-048XR manual Controls & Indicators

Contents

Operating Guide Page Contents Features Introduction Technical Support and Service Wrist Strap Belt Clip UH-048XROperating Guide Slide the battery cover forward until it snaps into place Battery InstallationGetting Started LOW Battery Alert Indicates a fully powered unit. As the batteries lose PowerBelt Clip Corner Wrist Strap Power ON/OFF VolumeOperation Press and hold Press to To Transmit and ReceiveWill be displayed TX indicators TX indicators will then disappear on the LCD Display showsTransmission is being received by your radio Transmission Monitor. Press ScanningFlashes Press or to Select up or down Continuous Tone Coded Squelch System Ctcss Programming Ctcss Code Ctcss Tone Display VOX Recovery Time Voice Activated VOXPress to confirm your To set the timing Press Function button until appears Auto Keylock Radio momentarily beeps as appears on Call MelodyTo deactivate keylock temporarily, press and hold Monitor To use monitor Battery Level Display Level Battery Charge UHF Channels & Frequencies Accessories Optional AccessoriesAC Adaptor AAD-048 Desk Top Charger DTC-048 Speaker Microphone SM-048 Headset Microphone HM-048 General Transmitter Receiver Warranty Uniden UH-048XR UHF CB Radio Procedure for obtaining performance or warranty Controls & Indicators External Mic/Speaker Page Page Uniden Australia Pty Limited/ Uniden New Zealand Limited