TO OPERATE uh073sx IN DUPLEX MODE
Eg. CH01 is being used in your area for repeater use.
Press | dup | momentarily. The DUP icon appears. |
Press | dup | again to deactivate the duplex operation. |
uh073sx will return to simplex operation.
Check with your local retailer for available repeaters.
SCANNING
The uh073sx has two types of scanning; Open Scanning (OS) and Group Scanning (GS).
Scanning allows you to search for active channels programmed in the OS or GS memory.
To initiate scanning;
1.Assuming the unit is on CH17 when switched on.
2.Press scan and scanning starts. Scan icon flashes during scanning.
Open Scan (OS) Mode (the absence of GS icon indicates that the unit is on OS mode)
Allows continuous scanning of channels stored in the Open Scan (OS) memory. If an active channel is found, scanning will stop on that channel.
The factory has preprogrammed all the 40 UHF channels into the Open Scan channel memory. However, you can change or customize the channels by following the steps on programming Scan Channels on page 15.
Example: CH40 becomes active
If the received signal cease, the unit will wait for at least 3 seconds for the signal to return, otherwise scanning resumes.
To skip the active channel, press mem momentarily. Scanning resumes.
To deactivate SCAN, press scan or PTT .
13
