INSTALLATION
MOBILE STATION INSTALLATION
Plan the location of the transceiver and microphone bracket before starting the installa- tion. Select a location that is convenient for operation and does not interfere with the driver or passenger in the vehicle. The radio should be securely fastened to some solid face, us- ing the mounting bracket and
MOBILE STATION ANTENNA
Since the maximum allowable power output of the transmitter is limited by the D.O.C., the antenna is a very important factor affecting transmission distance. It is for this reason that we strongly recommend that you install only a quality antenna in your new citizens band system. You have just purchased a superior transceiver. Don'tdiminish its performance by installing an inferior antenna.
Only a properly matched antenna system will allow maximum power transferfrom the 50- ohm transmission line to the radiating element. Your Uniden dealer is qualified to assist you in the selection of the proper antenna to meet your application requirements.
For automobile installation, the whip antenna may be used with good effect. The most effi- cient and practical installation is a full quarter wave whip antenna mounted on the rear deck or fender top midway between the rear window and bumper.
A short "loaded" whip antenna is more convenient to install on your automobile, although the efficiency is less than a full quarter wave whip antenna.
For marine installation, consult your dealerfor information regarding an adequate ground- ing system and prevention of electrolysis between fittings in the hull and water.
GROUND SYSTEM
Connect the red DC power cord from the transceiver to the positive, or (+), battery terminal or other convenient point and connect the black power lead to the chassis or vehicle frame, or
SELCALL
SELCALL (Selective Calling) is a special Squelch System which quiets your receiver until it receives an Encoded signal from another set which matches the one installed in your set. This means your set will remain quiet and not receive idle chit chat or other signals until the station you want to hear calls.
SELCALL is not initially installed in your set (each one has to be individually programmed) but may be purchased as an option.
OPERATING PROCEDURE TO RECEIVE
1.Be sure that the power source, antenna and microphone are connected to the proper connectors before going to the next steps.
2.Turn the unit ON by rotating the OFF/VOLUME Control clockwise.
3.Set the CHANNEL SELECTOR switch to the desired channel.
