Using the Speed Dial Memory
Storing Numbers in Speed Dial Memory
Your cordless phone can store up to ten numbers (up to 20 digits each) in the speed dial memory. To store number in memory:
1)When the phone is in standby, press [memory]. The talk/batt low LED flashes.
2)Use the keypad to enter the phone number.
(To enter a
3) Press [memory] again.
4) Select the speed dial location where you would like to store the number ( [0] to [9] ). You will hear a confirmation tone indicating that the number has been stored.
NOTE:
• Storing a number to a speed dial location will overwrite the any previously stored number without warning.
•When storing numbers into memory and the handset is idle (i.e., no key is pressed) for more than 30 seconds, it will beep rapidly, and then the phone will return to standby.
Dialing a Stored Speed Dial Number
1)When the phone is in standby, press [talk], and listen for a dial tone.
2)Press [memory] and enter the speed dial entry ([0] – [9]) that has the stored number you want to dial. (If you enter a digit that does not contain a stored number, the handset will beep rapidly, and the phone will not dial.)
Chain Dialing
The speed dial memory is not limited to phone numbers. You can store any number (up to 20 digits) that you need to enter once your call connects. This is referred to as Chain Dialing. For example, you can save your bank account number to speed dial memory. When you call your bank's telephone teller service and are prompted to enter your account number, simply press the [memory] and the speed dial number where you stored your account number.
Erasing a Stored Number from Memory
1)With the phone in standby, press [memory] twice.
2)Press the number of the speed dial entry. A tone indicates that the stored number is erased from memory.
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is not necessary.
The first time you charge your handset, the security code is automatically set. In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code.
1)Pick up the handset from the base unit. Press and hold [find] on the base.
2)While holding [find], place the handset in the base unit. Leave the handset in the base for more than three seconds. A new random security code is set.
NOTE: If the handset battery pack is completely discharged or the battery pack is removed, the digital security code will be lost. If this happens, a new security code is set automatically next time the battery pack is charged.
Warning!
Uniden DOES NOT represent this unit to be waterproof. To reduce the risk of fire, electrical shock, or damage to the unit, DO NOT expose this unit to rain or moisture.
1410 OM.indd 7 | 3/6/08 2:01:33 PM |
