Unigreen Trolleys and Barrows manual Preparing chemicals for spraying, Filling the tank

WARNING

•For electric appliances with three-phase motors, particular attention must be paid to ensure the direction of rotation of the motor corresponds to that shown on the reducer. If this is not the case, contact a Skilled Technician who will be able to solve the problem by simply inverting a wire inside the power plug. Failure to comply with the above will result in considerable damage to the appliance.

4.1.2Preparing chemicals for spraying

CAUTION

•Keep products in a ventilated place with a door that can be locked. Products must be kept out of reach of children and unauthorised adults. Appropriate warning notices should be placed outside to inform of the danger.

•Read instructions and safety information provided on the chemical product’s container carefully so that the most appropriate action may be taken to avoid endangering oneself or the environment. It is especially important that the maximum recommended concentrations are not exceeded, that only the amount of product needed for the treatment is prepared and that spillages onto soil and into water are avoided.

•Should chemicals come into contact with your eyes, wash immediately with water. Contact a doctor without delay and remember to take the product’s container with you.

•Should chemicals be swallowed, do not provoke vomiting. Contact a doctor without delay and remember to take the product’s container with you. Avoid inhaling the fumes that develop by using appropriate equipment for personal protection (a mask, for example). Drinking, eating and smoking are prohibited.

•Always wear suitable protective clothing and keep children, unauthorised adults and personnel without protection at a safe distance.

•Always wash your hands and face carefully after finishing work.

•All garments that have come into contact with chemicals must be washed thoroughly. Any item that may have been contaminated must be cleaned immediately.

•The containers used for chemicals must be disposed of according to current legislations in the country where the appliance is used.

4.1.3Filling the tank

CAUTION

•Pay particular attention to the instructions contained in the section on “Preparing chemicals for spraying”.

•Take care to avoid spilling the product onto the ground or into water when filling the tank.

•Water must only be added to the tank using free-fall water pipes or indirectly (jugs, drums, etc). The hose used for filling must never come into contact with the liquid contained in the tank. Do not connect up to the mains supply of drinking water.

•Do not over fill the tank; only fill with the amount of product needed for spraying.

a)Turn the cover (2) anti-clockwise and check that the aperture located in the middle is not blocked.

b)Check that the filling filter (23), the inside of the tank and the internal intake filter (22) (only CR 50) are clean.

c)Fill up with the product to be sprayed. We recommend a trial run with clean water before starting to spray with product for the first time in order to check the appliance is working correctly and to get used to operating it.

d)Close the cover (2) again, turning it clockwise but not forcing it.

17