United States Stove 1600EF Furnace Assembly Instructions, Shaker Grate Handle, Door Handles

FURNACE ASSEMBLY INSTRUCTIONS

Read and follow these instructions in the event you have		SHAKER GRATE HANDLE
to replace or re-assemble components of your furnace.	Insert the Shaker Rod into the hole on the ash door frame
DOOR HANDLES
	as shown. Then attach the Shaker Bracket to the front of
Insert door handle into door. From rear side of door, place	the furnace using two 1/4-20 x 3/4” Hex Bolts and two 1/4-
	20 Lock Nuts. Next, insert the shaker Rod into the bracket
a 1/2” washer over the threaded part of the handle, then
	and attach to the shaker grate bar using the 1/4-20 x 1”
attach the lock nut. Tighten the nut, then back off 1/4
	Hex Bolt and a 1/4-20 Lock Nut. The bolt and nut retaining
turn to allow free operation of the handle.
	the shaker bar and rod should be left loose to allow free
Follow these same directions for the ash door handle as-
	movement of the grates.
sembly.
	(1)	Shaker Rod
	(1)	Shaker Bracket
(2) Door Handle	(1)	1/4-20x 1” Hex Bolt
	(2)	1/4-20 x 3/4” Hex Bolt
(2) 1/2” Washer
	(3)	1/4-20 Lock Nut
(2) 1/2” Lock Nut
		BRACKET

ASH DOOR SPIN DRAFT

Screw the spin draft onto the 3/8” x 2-1/2” carriage bolt. Then screw the spin draft and bolt into the ash door al- lowing approximately 1/2” of the bolt to stick through the back side of the ash door. Secure the bolt in place with the 3/8”-16 lock nut.

(1) Spin Draft

(1) 3/8-16 Carriage Bolt

(1) 3/8-16 Lock Nut

FUEL & ASH DOOR LATCH

With two 1/4-20 x 3/4 hex bolts each, attach the door latches to the door latch mounting brackets on the left side of the door frames as illustrated. The slots in the brack- ets and latches are for door seal adjustment. Make the proper adjustments, then tighten the nuts. The door’s gas- ket should be snug against the door frame on the furnace.

SMOKE CURTAIN

Using two 1/4-20 x 1-1/4” Carriage bolts, the smoke cur- tain clips and two nuts, attach the smoke curtain in place above the Fuel Feed Door as shown below. After installa- tion, the smoke curtain should swing freely back into the furnace.

		Feed Door	Ash Door
(1) Feed Door Latch		Illustration	Illustration
(1)	Ash Door Latch
(4)	1/4-20 x 3/4 Hex Bolt
(4)	1/4-20 Kep Nut

(1)	Smoke Curtain	(2)	Smoke Curtain Clips
(2)	1/4-20 x 1-1/4 Carriage Bolt	(2)	1/4-20 Kep Nut

1/4-20 NUT

SMOKE CURTAIN CLIP

1/4-20 x 1-1/4

CARRIAGE BOLT

SMOKE CURTAIN

NUT

BOLT

SMOKE CURTAIN

CLIP

SMOKE CURTAIN

FRONT

USSC

9