![](/images/new-backgrounds/1117790/11779023x1.webp)
Installing Model 1005 Repeater Hub
NOTE: Rackmount screws and clip nuts are NOT provided with the Model 1005 Repeater Hub.
To install the Model 1005 Repeater Hub in
T R A N S I T I O N
1.Locate four (4) screws (and clip nuts, if necessary) for each Model 1005 Repeater Hub to be installed.
2.Carefully align the Model 1005 Repeater Hub between the 19- inch rack mounting rails at the installation position.
3.Install two screws through right front bracket and two screws through left front bracket, using clip nuts if necessary.
To install the Model 1005 Repeater on table or other flat surface:
1.Carefully turn Model 1005 Repeater Hub to side.
2.Install four (4) rubber feet (provided with repeater hub):
•Remove protective paper from adhesive surface of rubber foot.
•Position rubber foot at bottom corner of repeater hub.
•Secure rubber foot to repeater hub surface.
•Repeat for remaining rubber feet.
3.Return Model 1005 Repeater Hub to upright position.
Connecting Cable to SIC and RJ-45 Connectors
Connections between installed Model 1005 Repeater Hub SICs or between a Model 1005 Repeater Hub SIC and a hub or terminal device include:
•Female AUI Connector/10Base5
•Male AUI Connector/PC
•RJ Connector/10BaseT
•BNC Connector/10Base2
•ST Connector/Fiber Optic
BNC Connector/10Base2 Connection
The thinnet coaxial card
|
|
|
|
|
| NOTE: Verify that coax |
|
|
|
|
|
| cables on Model 1005 |
|
|
|
|
|
| Repeater Hub are terminated |
|
|
|
|
|
| properly at both ends. |
| 50 ohm terminator | (In a coax thinnet installation, | ||||
|
|
|
|
|
| the first and last device in a |
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| terminated with a 50 ohm |
|
|
|
|
|
| terminator.) |
|
|
|
|
|
| Additionally, the 10Base2 |
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| segment must be grounded to |
|
|
|
|
|
| |
|
|
|
|
|
| “earth ground” at one end. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
50 ohm terminator
9 | Model 1005 | Ethernet™Repeater Hub | 10 |