Universal Remote Control MRF-260 Close the RF window and Download to the Remote

MRF-260BASE STATION

In the figure below, each device is set to a specific flasher.

Note: Remember, the MRF-260 will only respond to selections 1 through 4.

Step 5 - Make sure that the ID# is set on both the remote and on the wheel of the MRF-260.

Click on the Receivers button and set the RF address to one of the first 15 addresses (1-9 or A, B, C, D or E). The second set of address- es is only supported by MSC units.

Step 6 - Close the RF window and Download to the Remote.

Page 9