Universal Remote Control UR-J550TVE manual Instructions, Batteries, Helpful hints, Operation

Operating Manual for 2 in 1 Cable TV Remote Control

UR-J550TVE

Universal Remote Control, Inc.

www.universalremote.com

OEE-0017D Rev 03(05/14/02)

Instructions

This remote control is preprogrammed to operate CABLE Box.

Please program it for your TV by following the instructions shown below.

Batteries

The remote control uses AAA batteries. Please be sure to match the batteries with the (+) and (- ) markings inside the battery compartment during installation.

Install two AAA alkaline batteries as shown here

Press arrow gently &

pull down to remove cover

Programming your remote control

Setup for your cable box

No setup is required. The remote control is preprogrammed to operate your cable box.

Setup for your TV

Find your TV brand and its three-digit code on the back of this manual. If the TV brand is not listed, please use the Searching Method in STEP3 .

STEP1 Turn on your TV manually.

*Tip : If you have RCA TV, don’t turn on the TV.

STEP2 Press [TV POWER] and [MUTE] buttons simultaneously until the red light is on.

STEP3 Point the remote control toward the TV and enter the three-digit code from the code table. If there is more than one code number assigned to your TV brand, try one code number at a time until the TV turns off right after you entered the number.

Searching Method

Press [CH +] button and hold until the TV turns off. As soon as the TV turns off, release [CH+] button.

*Tip : You can confirm the power off and on by pressing [MUTE] button.

STEP4 Press [TV POWER] button to store the three-digit code.

*Tip: Red light will blink twice.

Three-digit code :

Set-up for your VOLUME control

The remote control is preprogrammed to control VOLUME and MUTE functions through your TV. To switch VOLUME and MUTE functions to your Cable Box:

STEP1 Press [ ] and [MUTE] buttons simultaneously until red light is on.

STEP2 Press [VOLUME +] button.

STEP3 Press [ ] button.

To return to the TV’s VOLUME, press [TV POWER] button.

*Tip: Red light will blink twice.

Set-up for advanced functions

A. To turn on your TV and Cable at the

same time with button:

STEP1 Press [ ] and [0] buttons simultaneously until the red light is on.

STEP2 Press [CH +] button.

*Tip: Red light will blink twice

The [ ] button sends out the TV and CABLE power commands if you

press the [ ] button.

To return to the original function, press the [CH-] button in the STEP2 .

B. Recalling the TV Three-digit code :

STEP1 Press [TV POWER] and [MUTE] buttons simultaneously until the red light is on.

STEP2 Press [VOLUME -] button.

The red light will blink a number of times indicating the number of each digit of the code. Each digit is separated by one second interval of red light being off.

*Tip: One blink, three blinks and 10 blinks, indicates the code number 130.

Helpful hints

Set-up for your Cable Box

The remote control is preprogrammed to control your cable box. If it does not work properly, please set-up the right code by using the three-digit code or searching method.

If you have a TV with a remote control, we recommend that you plug its power cord directly into a wall outlet if available (your cable installer may select an alternate setup)

Operation

If red light does not blink when you press keys the operation is intermittent:

Make sure the batteries are inserted correctly.

Replace old batteries with two new

AAAbatteries. Please do not mix old batteries with new ones.