Enviro C-11290, C-10381 Kit Parts List, Conversion Kit Installation, Maintenance And Service

Maintenance And Service

Fuel Conversion:

TO BE INSTALLED BY A QUALIFIED SERVICE AGENCY ONLY

Please read and understand these instructions before installing.

Warning: This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer’s instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in these instructions is not followed exactly, a fire, explosion or production of carbon monoxide may result causing property damage, personal injury or loss of life. The qualified service agency is responsible for the proper installation of this kit. The installation is not proper or complete until the operation of the converted appliance is checked as specified in the manufacturer’s instructions supplied with the kit.

Kit Parts List:

1 - Orifice (NG - #39 DMS or LP - #53 DMS)

1 - Pilot Injector (NG 0.62 mm; LP 0.35 mm)

1 - Installation instruction sheet

1 - Conversion label

Carefully inspect all parts supplied with this conversion kit. If any parts have been damaged or are missing, contact your dealer, distributor or courier company to have them replaced before starting this installation.

Conversion Kit Installation:

1.Turn control knob on the gas valve to the “OFF” position and shut the gas supply off at the shut-off valve upstream of the unit. CAUTION:

The gas supply must be shut off prior to

disconnecting the electrical power and								Rotate handles
before proceeding			with	the	conversion.			and remove the		Pilot assembly moved
Allow the valve and unit to cool down to								door and glass.		from firebox for clarity.
room temperature.
2. Remove	the	glass	as	shown		in	the
Maintenance		and Service		-	Glass		Door
Removal.
3. Carefully remove the log set and ember										Lift off the pilot
material if they are installed.										head and replace
										with proper pilot
4. Remove	the	burner as		shown		in	the
										orifice for fuel type
Maintenance and Service - Burner Removal.										to be used.
5. Convert the burner orifice(s):
a) Remove the main burner orifice with a
½ inch deep socket.
b) Put a bead of pipe-thread sealant or
approved		Teflon	tape	on	the	orifice		Using a ½" deep		Undo the two
threads before installing into the brass										(2) screws that
								socket remove/reinstall
elbow.								the main burner orifice.		hold burner in
									Venturi adjustment	the firebox.
c) Install the new orifice(s) from the kit
									bracket.
into the brass elbow.								Figure 8: Unit burner shown apart.

11