Enviro C-10381 OperatingInstructions, For Your Safety, Read Safety Precautions And, Eli H Wt Oh

MAY

TI NRUF, GNI HT OLC, NERDLI HC PEEK. HCUOT T ON OD. GNI AREP

ELI H WT OH

. YA WA SRUOPAV ELCAUBAMMALF TREHTIOR N, E I :L OSAG

cal perif si ht et ar epot on o D: YT FAS RUOY ROF

a yb dna noit sub moc r of

snoi si vor p hti

w dell at sni

gnit ar epo dna noit all at sni

LIFE.

ee S.ri a noit alit nev evah

ni a mr o eci vr e

, oit ar etl a,t ne mtsujEXPLOSIONOFda, noit all at sni

e mrofr ep ebt

meci vr es dna noitORall at snI .l auna m

OperatingInstructions

For Your Safety, Read Safety Precautions And

Lighting Instructions Before Operating YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY A FIRE CAUSING PROPERTY DAMAGE, PERSONAL INJURY OF LOSS

FOR YOUR SAFETY READ BEFORE OPERATING

WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT

CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.

A) This appliance is equipped with a pilot, which must be lit by hand by

If you cannot reach your gas supplier, call the fire department.

following

C) Use only your hands to push in or turn the gas control knob; NEVER

these instructions exactly.

use tools. If the knob will not push in or turn by hand, do not try to repair,

B) BEFORE LIGHTING, smell all around the appliance area for gas and next to

may result in a fire or explosion.

the floor because some gas is heavier than air and will settle on the floor.

D) Do not use this appliance if any part has been underwater. Immediately

WHAT TO DO IF YOU SMELL GAS:

call a qualified service technician to inspect the appliance and to replace

Do not try to light any appliances. Do not touch any electrical switch. Do not

any part of the control system and any gas control which has been

use any phone in your building.

under water.

Immediately call your gas supplier from a neighbours phone. Follow the gas

LIGHTING INSTRUCTIONS

1. STOP! Read the safety information above on this label.

WARNING: This gas valve has a lockout dev ice, which will not allow

the pilot burner to be relit until the thermocouple has cooled. If the

2. Turn off all electrical power to this appliance.

knob does not pop up when released, stop and immediately call

3. Turn off the gas control knob clockwise

to the off position.

your service technician or gas supplier.

4. Open door. Wait five (5) minutes to clear out any gas. Close door. If you

smell gas, including near the floor, STOP! Follow 'B' in the above safety

6. Turn the gas control knob counter-clockwise

to the 'ON'

information. If you do not smell gas go to the next step.

position. Flip the burner switch

5. Find pilot located to the right behind the side log. Turn the gas control

to 'ON' THEN TURN THE 'HI/LOW'

knob counter-clockwise

to 'PILOT'.

Instructions:

knob to the desired setting.

Push the gas control in fully and hold.

7. Turn on the electrical power to the unit.

Keep knob depressed for about 30 seconds

OUT

IN

after pilot is lit. Release knob. If pilot goes

H

O

OFF

L

I

out repeat steps 4 through 5.

P

I

L

O

T

NO

T

I P

OL

TO TURN OFF GAS TO APPLIANCE

TTTPHTH

IF

ws r enr ub pil F. 1

.' FF O' otRESULT,hcti

ecnail ppa eht ot r e wopl acirt cel ell aff o nr uT. 3

op' FF O' eht ot

esi wkcol c bonkl ort noc sa eht nr uT. 2

eb ot si eci vr esfi

. de mrofr ep

WARNING:

ighting

18301- C

Pilot L

Figure 2. Lighting Instruction Label

6