Universal Security Instruments MPI305, MPI305L manual

SECURITY INSTRUMENTS, INC.

MODEL MPI305, MPI305L

MODEL MPI505, MPI505L

SMOKE & FIRE ALARM WITH SILENCE FEATURE

AND ALARM ORIGINATION FEATURE

READ ALL INSTRUCTIONS

This smoke alarm uses an extremely small amount of a radioactive element in the ionization chamber. Do not tamper with radioactive sealed source or try to repair the smoke alarm yourself.

Table of Contents:
	Page #
Smoke Alarm Limitations and Functions .................................	2
Recommended Location of Alarms .........................................	3
Avoid These Locations ...........................................................	4
Early Warning .........................................................................	4
Installation Instructions ...........................................................	4
Locking/Tamper Feature .........................................................	4
Operation, Testing & Maintenance ..........................................	5
Quick Find® Alarm Originating Feature & Reset ......................	5
Cautions/Warnings .................................................................	6
Battery Replacement ..............................................................	7
Develop and Practice a Plan of Escape ..................................	7
Operational Summary .............................................................	8
Warranty .................................................................	Back Cover

Contents

Smoke Alarm Limitations and Functions Recommended Location of Alarms Avoid These Locations Installation Instructions Locking/Tamper Feature SMOKE ALARM LIMITATIONS AND FUNCTIONS RECOMMENDED LOCATION OF ALARMS •Locate at least one smoke alarm on every floor level AVOID THESE LOCATIONS •the garage – products of combustion are produced when you start your vehicle in areas where temperature may fall below INSTALLATION INSTRUCTIONS: CAUTION!! READ CAREFULLY CAUTION: THIS SMOKE ALARM IS SEALED. THE COVER IS NOT REMOVABLE 1.Use long nose pliers to pull the locking pin out of the hole 2.It is now possible to remove the smoke alarm or replace the battery 1.Attach the mounting bracket to the wall or ceiling (your preference) To activate 9 volt battery and alarm, hold the QUICK DRAW 3.Push and twist the alarm clockwise onto the mounting bracket (UTHA) Sensitivity Indicating Means (UTHA) Go/No-GoField Test (UTHA) MAINTENANCE: BATTERY REPLACEMENT REPAIRS AND SERVICES in-warranty DEVELOP AND PRACTICE A PLAN OF ESCAPE BASICS OF ESCAPE PLAN WHAT TO DO WHEN THE ALARM SOUNDS OPERATIONAL SUMMARY DC Power is present Service and getting out of the home "AVOID THESE LOCATIONS" section). Reset alarm as instructed below Visit Us on the Web