| HARDWARE CONTENTS |
ILII= I Ill | IIIIIJllllllll III ILIIIIIIIIIIIIIIIIII IIIIIIII I II UJJ _ |
| PARTS PACKED SEPARATELY IN CARTON NOT SHOWN ACTUAL SIZE | |
Operator's Manual | Concentrator Nozzle | |
Upper Vacuum Tube | ||
|
Blower Tube | Flare Nozzle | Lower Vacuum Tube |
|
|
ASSEMBLY
REMOVE BLOWER FR'bM CARTON
-Remove loose parts included with Blower/vac.
• Remove all packing material.
•Check carton thoroughly for additional loose parts.
ASSEMBLE YOUR UNIT INTO A BLOWER OR VACUUM MODE
You can assemble your unit as a blower or a vacuum, Later
you can refer to these instructions and reconfigure your unit into a different mode. The instnJctions below provided information on how to assemble your unit for both configurations.
HOW TO ASSEMBLE YOUR UNIT AS A BLOWER
If your unit is configured in the vacuum mode, follow the following steps to prepare your blower for blower mode.
If your unit is not in the vacuum mode, continue with
"ATTACHING THE BLOWER TUBE & NO_LE."
•Stop the unit.
•Remove the vacuum tubes and collection bag.
•Latch the inlet cover closed, and replace the screw.
ATTACHING THE BLOWER TUBE & NOZZLE
(Fig. 1, & 2)
Remove the blower vacuum tubes and collection bag, if assembled to the unit.
•Insert the blower tube into the blower outlet.
•Turn the blowertube clockwise until it is firmly seated in the blower outlet.
•With a slight twisting motion, slide nozzle firmly onto the end of the blower tube.
/
Blower Outlet
Figure 1
Blower Tube ,. | _ | Blower Tube |
Concentrator | Nozzle | _""_ | Flare Nozzle |
Figure 2
HOW TO ASSEMBLE YOUR UNIT AS A VACUUM
VACUUM TUBES ASSEMBLY (Fig. 3,& 4)
STOP THE UNIT AND DISCONNECT IT FROM
WARNINGTHE POWER SOURCE BEFOREOPENING THE INLET COVER ORATTEMPTINGTO INSERT OR REMOVE THE VACUUM TUBES. THE MOTOR MUST BE STOPPED AND THE IMPELLER BLADES NO LONGER TURNING TO AVOID SERIOUS INJURY FROM THE ROTATING BLADES.
The lower vaccum tube is cut at an angle. Make sure the label on the lower vacuum tube is aligned on the opposite side of the screw tab on the upper vacuum tube before pushing the two tubes together.
•Push the upper and lower vacuum tubes together.
oUsing a Phillips screwdriver, remove the screw from the inlet cover.
•Press the locking latch and open the inlet cover.
•Holding inletcover open, push assembled vacuum tubes into the opening until the locking latch engages.
•Reinstall screw.
Locking Latcb.,.__
Inlet cove,:. | _) | _/_ |
Figure 3
Upper
Vacuum Tube
Lower
Vacuum Tube
tnlet cover
Air Intake Openin!
Figure 4