Univex 79838 manual Ttaching coLLEcTION BAG Fig, Adjusting the Shoulder Strap on, Collection BAG

ASSEMBLY

......

,_TTACHING coLLEcTION BAG (Fig. 5)

•Slide the opening of the collection bag over the blower

outlet. Pull the strap with Velcrotightlythroughthe buckle and secure the Velcro tabs.

NOTE: Make sure the strap with Velcm is located between the motor housing and the collar on the blower outlet.

Strap

with Velcro

Collection Ba, Collar on Blower Outlet

Figure 5

ADJUSTING THE SHOULDER STRAP ON THE

COLLECTION BAG (Fig. 6, & 7)

•Carefully loop the shoulder strap through the buckle as shown in the illustration, Notice the first in and last in is the same hole.

•With your left hand hold the unit in an upright position, Support the lower vacuum tube on the ground, Make sure the blower outlet and collection bag are positioned on your right-hand side.

°Place the shoulder strap over your right shoulder.

•Adjust the shoulder strap to allow a free flow of air from the blower outlet. If the collection bag is kinked, the unit wil! not operate properly.

NOTE; The shoulder strap is designed to position the collec- tion bag on your shoulder without kinks. The strap is not in-

tended to support the weight of the unit.

Last In

First	lnJ_
	Figure	6
Shoulder	strap
on right	shoulder	Free flow of air.
		No kinks In
		collection bag

,I I IIL]] I n , ,,n III I,,I n lU l,

BLOWER CONVERSION

°Stop unit and disconnect from power soume.

o Remove the vacuum tubes and collection bag.

•Secure the inlet cover making sure that thetatch is se- curely fastened and screw is reinstalled.

°Reinstall the blower tubes. Refer to "Blower Tube Assembly" section.

EXTENSION CORD (Fig. 8, & 9)

Use only a voltage supply as shown on the nameplate of the unit to power your unit.

The extension cord used to reach the power source must be:

•Specifically marked as suitable for outdoor use. The cord must be marked with the suffix "W-A. ("W in Cana- da).

•Heavy enough to carry the current from the power source the full length of the extension cord to the unit. Otherwise, loss of power and overheating can occur causing damage to the unit. Refer to Figure 8 for minimum wire gauge recommendations. The cord must be marked with the proper wire gauge.

-In good condition. Cord insulation must be intact with no cracks or deterioration, Plug connectors must be un- damaged.

Secure extension cord to unit as follows:

•Tie cord from unit to extension cord.

°Plug cord from unit into extension cord.

To reduce the risk of electric shock, this unit has a polarized plug (one blade is wider than the other). This plug will fit in a polarized extension cord only one way, If the plug does not fit fully into the extension cord, reverse the cord.

If it still does not fit, make sure you have a polarized extension cord. if the extension cord does not fit into the outlet, reverse the cord. If it still does not fit into the outlet,

contact a qualified electrician to install the proper outlet. Do not change the plug or socket of the unitor extension cord in

any way.

MINIMUM WIRE GAUGE

RECOMMENDATIONS

VOLTS	25 FT.	50 FT.	100 FT.	150 FT.
120	16	16	14	12
A.W.G.*		A.W.G.*	A.W.G.*	A.W,G.*
*American Wire Gauge		Figure 8
Extension	Cord

Cord from Unit

Figure 7

Figure 9