Mise EN Garde Veiller à ne pas trop serrer la vis

1.Locate the BOTTOM COVER (#6). Position the cover as shown with the notch of the center hole facing downward. Slide the BOTTOM COVER down over the UPPER CONSOLE SUPPORT TUBE (A) until it rests against the FRONT TUBE EXTENSION (B).

2.Position the HANDLEBAR (#11) as shown near the UPPER CONSOLE SUPPORT TUBE (A).

3.Connect the 4-PIN HEART RATE CONNECTOR (4P) leading from the HANDLEBAR (#11) center to the 4-PIN HEART RATE CONNECTOR (4P) leading from the UPPER CONSOLE SUPPORT TUBE (A).

4.Carefully slide the HANDLEBAR MOUNTING FLANGES (C) into the UPPER CONSOLE SUPPORT TUBE (A).

NOTE: Be careful not to pinch the HEART RATE CABLE when inserting the HANDLEBAR FLANGES (C) into THE UPPER CONSOLE SUPPORT TUBE (A).

MISE EN GARDE: Faites attention à ne pas pincer le CÂBLE de FRÉQUENCE CARDIAQUE en insérant les BRIDES de GUIDON (C) dans LE TUBE SUPÉRIEUR de SOUTIEN de CONSOLE (A).

5.Secure the HANDLEBAR (#11) to the UPPER CONSOLE SUPPORT TUBE (A) using four MOUNTING BOLTS (#1). Tighten the SCREWS to 15-20 ft. lbs.

6.Locate the TOP COVER (#5). Slide the BOTTOM COVER (#6) upward toward the HANDLEBAR (#11) until it contacts the HANDLEBAR. Position the TOP COVER over the HANDLEBAR and align it to the BOTTOM COVER. Secure the TOP COVER to the BOTTOM COVER using four PHILLIPS SCREWS (#2) as shown.

7.Align the ACCESSORY TRAY (#3) to the bottom of the DISPLAY CONSOLE (#4) as shown. Secure the ACCESSORY TRAY to the DISPLAY CONSOLE using four PHILLIPS SCREWS (#2).

8.Position the DISPLAY CONSOLE (#4) near the top of the CONSOLE SUPPORT ASSEMBLY (D). Remove the protective cover on the COAXIAL CABLE (CX). Carefully align and connect the COAXIAL CABLE to the coaxial connector located inside the rear of the DISPLAY CONSOLE. Align the LOCKING TABS of the 14-PIN CONNECTOR, 5-PIN CONNECTOR, and the 4-PIN CONNECTOR and plug them into the matching connectors located inside the rear of the DISPLAY CONSOLE until they snap securely into place.

9.Carefully feed the wires back into the top of the CONSOLE SUPPORT ASSEMBLY (D) and attach the DISPLAY CONSOLE (#4) to the CONSOLE SUPPORT ASSEMBLY using the four CONSOLE SCREWS (#4) and a Phillips screwdriver. Tighten the four SCREWS securely in a criss- cross pattern.

NOTE: Be careful not to over-tighten the screws.