INSTALLING TO WALL
NOTICE
A qualified service person must install heater. Follow all local codes.
CHECK GAS TYPE
Use only natural gas. If your gas supply is not natural gas, do not install heater. Call dealer where you bought heater for proper type heater.
INSTALLATION ITEMS
Before installing the heater, make sure you have the items listed below.
• | piping (check local codes) | • | test gauge connection * (see |
• | sealant (resistant to propane gas) |
| Figure 10, page 11) |
• manual shutoff valve * | • sediment trap | ||
• | ground joint union | • | tee joint |
|
| • pipe wrench | |
*An A.G.A. design certified manual shutoff valve with 1/8" NPT tap is an acceptable alternative to test gauge connection. Purchase the optional A.G.A. design certified manual shutoff valve from your dealer. See ACCESSORIES, page 23.
LOCATING HEATER
This heater is designed to be mounted on a wall.
!WARNING
Maintain the minimum clearances shown in Figure 2 (page 6). If you can, provide greater clearances from floor, ceiling, and join- ing wall.
!WARNING
Never install the heater
•in sleeping quarters, a mobile home, or a recreational vehicle
•where curtains, furniture, clothing, or other flammable objects are less than 36 inches from the front, top, or sides of the heater
•as a fireplace insert
•in high traffic areas
•in windy or drafty areas
NOTICE
Do not install or operate heater in areas where impurities in the air (such as tobacco smoke) exist. Particles from these impurities may discolor walls.
Continued
5
