Vanguard Heating VMH3000TP Check GAS Type, Installation Items, Locating Heater

®

VENT-FREE GAS RESIDENTIAL HEATERS

INSTALLATION

NOTICE: This heater is intended for use as supplemental heat. Use this heater along with your pri- mary heating system. Do not in- stall this heater as your primary heat source. If you have a central heating system, you may run system’s circulating blower while using heater. This will help circu- late the heat throughout the house. In the event of a power outage, you can use this heater as your primary heat source.

WARNING: A qualified ser- vice person must install heater. Follow all local codes.

CHECK GAS TYPE

Use only propane/LP gas. If your gas supply is not propane/LP, do not install heater. Call dealer where you bought heater for proper type heater.

INSTALLATION ITEMS

Before installing heater, make sure you have the items listed below.

• external regulator (supplied by installer)
• piping (check local codes)
•	sealant (resistant to propane/LP gas)
•	equipment shutoff valve *

LOCATING HEATER

WARNING: Maintain the mini- mum clearances shown in Figure

10.If you can, provide greater clearances from floor, ceiling, and joining wall.

You can locate heater on floor. The op- tional hearth base is needed. You can also install optional decorative mantels on the heater (some mantels require the hearth base). IMPORTANT: Only use optional mantels and hearth base specified in this manual. Purchase the optional mantel and hearth base from your dealer. See Accesso- ries, page 23.

The heater may also be mounted on a wall. You cannot use optional mantel if mounting heater on a wall.

WARNING: Never install the heater

•in a bedroom or a bathroom

•in a recreational vehicle

•where curtains, furniture, clothing, or other flammable objects are less than 36 inches from the front, top, or sides of the heater

•as a fireplace insert

•in high traffic areas

•in windy or drafty areas

CAUTION: This heater creates warm air currents. These currents move heat to wall surfaces next to heater. Installing heater next to vinyl or cloth wall coverings or operating heater where impurities (such as tobacco smoke, aromatic candles, cleaning fluids, oil or kerosene lamps, etc.) in the air exist, may discolor walls.

IMPORTANT: Vent-free heaters add mois- ture to the air. Although this is beneficial, installing heater in rooms without enough ventilation air may cause mildew to form from too much moisture. See Fresh Air for Com- bustion and Ventilation, pages 5 through 7.

CAUTION: If you install the heater in a home garage

•heater pilot and burner must be at least 18 inches above floor.

•locate heater where moving ve- hicle will not hit it.

For convenience and efficiency, install heater

•where there is easy access for operation, inspection, and service.

•in coldest part of room.

An optional fan kit is available from your dealer. See Accessories, page 23. If plan- ning to use fan, locate heater near an electri- cal outlet.

•	ground joint union
• test gauge connection *
•	sediment trap

CEILING

• tee joint

• pipe wrench

* A CSA/AGA design-certified equipment

shutoff valve with 1/8" NPT tap is an ac-

ceptable alternative to test gauge connec-

tion. Purchase the optional CSA/AGA de-

sign-certified equipment shutoff valve from

6" Minimum From Sides Of Heater

36" Minimum

your dealer. See Accessories, page 23.

Left	Right
Side	Side

	5" Minimum To Top Surface
FLOOR	Of Carpeting, Tile Or Other
	Combustible Material

Figure 10 - Mounting Clearances As Viewed From Front of Heater

8 104432