Varimixer manual Motor Removal Instructions Models W30-W150

Motor Removal Instructions

Models W30-W150

PLEASE REFER TO THE DIAGRAM ON PAGE 2

1REMOVE NUT (J) AND SHIM WASHERS (H)

2PRY OFF FORK ASSEMBLY (X).

3REMOVE SPECIAL V-BELT (A).

4REMOVE TWO 17MM BOLTS (V)

5REMOVE 4 BOLTS FROM MOTORPLATE (T).

6ON OLDER MODEL MIXERS WITH SINGLE PHASE MOTORS,IT MAY BE NECESSARY TO DISCONNECT THE START & RUN CAPACITORS FROM THE SIDE OF THE MOTOR BEFORE LIFTING THE MOTOR OUT OF THE MIXER.

7LIFT MOTOR OUT OF MIXER BODY. SET MOTOR ASSEMBLY ON A BOARD LAYED ACROSS THE TOP OF THE MIXER.

8DISCONNECT WIRE HARNESS FROM MOTOR.

NOTE: DO NOT FOLLOW STEPS 9-12 IF YOU ARE REPLACING THE WHOLE ASSEMBLY. (MOTOR ,GEARBOX,MOTOR PLATE AND PULLEY.

9GRASP TOP PULLEY (W) AND BANG AGAINST CLAMPING RING & WASHER (S) THIS ACTION WILL REMOVE PULLEY FROM MOTOR SHAFT.

10REMOVE 4 SLOTTED HEAD SCREWS FROM MOTOR PLATE TO MOTOR. REMOVE MOTOR PLATE.

11INSTALL MOTOR PLATE ONTO MOTOR,TIGHTEN 4 SLOTTED HEAD SCREWS. INSURE CAPACITORS WILL FACE THE REAR OF THE MIXER WHEN MOTOR IS INSTALLED.

12INSTALL MOTOR PULLEY ONTO MOTOR SHAFT,TAKING CARE TO ALIGN KEY WITH KEYWAY. BANG TOP PULLEY AGAINST BOTTOM PULLEY UNTIL INSTALLED.

13PLACE MOTOR ON TOP OF MIXER AND CONNECT MOTOR TO HARNESS. (FOLLOW DIAGRAM ON MOTOR)

14LOWER MOTOR INTO MIXER BODY.INSTALL 4 BOLTS (T) TO THE MOTOR PLATE. DO NOT TIGHTEN!

15INSTALL 2 17MM BOLTS (V)

16MEASURING THE DISTANCE BETWEEN PULLEYS (B),ON 30QT. & 40 QT. THE DISTANCE SHOULD BE 11 1/2 INCHES.SLIDE MOTOR TO REACH THIS DISTANCE. ON 60QT.-150QT.,THE DISTANCE SHOULD BE 12 1/4"S.

17TIGHTEN 13 MM BOLTS (T) AND 17 MM BOLTS (V).

NEXT PAGE